Panasonic WVCU650 WJSX150 User Guide - Page 35

TIME-LAPSE VCR CONTROL MUX [NON-PANASONIC MODELS] (TERMINAL MODE) A time-lapse VCR is operable with the system controller, while connecting to the matrix switcher. Notes: • Before the use, it is necessary to install the Multiplexer board in the matrix switcher, connect the matrix switcher to the digital disk recorder, and configure the system through WJ-SX150A Administrator Console, OSD SETUP MENU, and time-lapse VCR's SETUP MENU. (Refer to the operating instructions of matrix switcher.) • You cannot control non-Panasonic time-lapse VCRs from system controllers. The following is the procedure of a non-Panasonic model time-lapse VCR. ■ Controlling the Time-lapse VCR ● Multiscreen Segment Switching The operations are the same as WJ-HD500 Series. (Refer to p. 19.) Note: 7-, 10-, and 13- segment multiscreen display patterns are unavailable. ● Normal Playback 1. Enter the recorder mode. (Refer to p. 19 Recorder Mode.) 2. Do the playback procedure using the buttons on the front panel. (Refer to the time-lapse VCR's operating instructions for how to operate.) 3. Press the PLAY/PAUSE button. The playback image will appear on the monitor. 4. To display the spot picture, press the numeric buttons corresponding to the desired camera number, then press the CAM (SET) button. Then, the active monitor number will appear on the LCD. (Refer to p. 20 Normal Playback for the illustration.) ● Other Operations Refer to the time-lapse VCR's operating instructions for how to operate. MONITOR DISPLAY CONTROL (PS·DATA) The operations are the same as System Controller WVCU360C/CJ. (Refer to the operating instructions of matrix switcher for how to operate.) However, the following operations differ from System Controller WV-CU360C/CJ. ■ On-screen Display (OSD) Control Refer to WV-CU950/650 Operating Instructions. ■ Video Loss History Table Refer to WV-CU950/650 Operating Instructions. 35