Pentax 205570 User Guide - Page 67
Time-Out When Charging,
UPC - 700908001030
View all Pentax 205570 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Time-Out When Charging The printer believes that too much time was required to bring the battery up to a normal charge voltage. A maximum of 150 minutes is allowed for the charging cycle. This is an indication that the battery should be replaced. Low Thermal Head Temperature The temperature of the thermal head is too low for reliable printing (less than -10°C). You need to use the printer in a warmer environment. If this condition occurs in relatively warm environment (for example, at room temperature), the printer should be returned for service. High Thermal Head Temperature The temperature of the thermal head is too high. If allowed to become even hotter, the thermal head would begin imaging the paper in areas not intended to be printed. The printer will stop while the head cools down and then will resume printing. This condition is normal when printing documents with a great deal of "black" content. To avoid or delay the onset of this condition, you can print using a lighter density setting, reduce the amount of "black space" being printed by removing background shading and colors (for example, background on Excel graphs or PowerPoint documents) and make sure that the printer is not enclosed and has adequate ventilation. Note: This condition may be worse at high altitude (>10,000 feet) due to a lower air density available to cool the printer. Data Receive Error Data is being received but errors are causing the printer to request that it be re-transmitted. This will slow printing speed and is almost always associated with the quality of an IrDA connection. Try repositioning the printer or host IrDA until the errors cease. Bad Checksum of Flash Data This indication is reserved for use during firmware or font uploads only. The firmware or font that was sent to the printer was either corrupt or was corrupted during transmission. Disconnect printer power to shut down the printer, and try sending the file again. If it Page 55