Pfaff 1221 Owner's Manual - Page 20

Changing the needle or sewing foot is easy. Vanous sewing operations require different size needles or special needles. A detailed Needle and Thread Chart is shown on page 61. To change the needle, lower the presser bar lifter and hick it to position D (see page 15) This causes the Stopmatic mechanism to bring the needle to the correct position for changing. Loosen screw N (see ill. below) and pull the old needle out of the needle holder Insert a new needle and push it up as far as it will go, making sure the flat side of its shank tacos toward the back. Now tighten the needle screw Use System 130 needles only. Changing the sewing foot is Just CS simple. The acctssory box of your macnine contains several special sewing feet (hemmer foot, buttonhole foot, etc ) which are used for venous sewing operations. Which sewing toot to use for a secrfrc ewrrtg job is discussed on page 21 and the following pages. To change the sewIng foot, push the presser bar lifter to ifs highest position. Loosen screw B until the sewing foot can be removed, tilt rug it sideways or backwards. The new sewing tnot is attached in me reverse order. Tighten screw B again betore starting to sew. 18