Pfaff creative sensation pro II Manual - Page 36
Buttons and indicators
View all Pfaff creative sensation pro II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
D B E C F G H I J A Soft Touch™ Buttons and indicators 5HYHUVHEXWWRQ$ For permanent reverse, press the button once before starting to sew. The reverse indicator (B) will be lit and the machine sews in reverse until you press the button again to cancel. If you press the reverse button while sewing, the machine sews in reverse for as long as you keep the button pressed. The reverse indicator is lit when the reverse button is pressed. Reverse is also used when sewing buttonholes, programmed tie-off end, darning stitches and tapering stitches to step between the parts of the stitch. 3UHVVHUIRRWGRZQDQGSLYRWWRJJOH( Lower the presser foot completely. Press the button once more to raise the presser foot to pivot height. The presser foot is lowered automatically when you start sewing. 6WDUWVWRS) Press this button to start or stop the machine without using the foot control. Press the button once to start and press it again to stop. To disable the start/stop button in sewing mode and only use foot control when sewing, activate start/stop button safety in the Settings menu. 5HYHUVHLQGLFDWRU% The reverse indicator will be lit when pressing the reverse button to sew in reverse. It is also lit while sewing permanent reverse. $FWLRQLQGLFDWRU& The action indicator is lit to indicate that an action is to be done, for example performing tapering. The icon stays lit until the action is done. 3UHVVHUIRRWXSDQGH[WUDOLIWWRJJOH' Raises the presser foot and needle to the up position. Press the button once more and the presser foot will raise to extra lift. The feed dogs will be lowered to make it easier to get thick fabric under the presser foot. 2:14 7KUHDGVQLSV* Press to cut both needle and bobbin thread immediately. If pressing this button while sewing, the threads will be cut before the needle moves to the start position of the next stitch. Your machine ties off the thread, cuts the needle and bobbin threads and raises the presser foot and the needle. The thread snips function can be programmed, see chapter 4. Note: Threads are cut automatically when buttonholes are sewn with the Sensormatic buttonhole foot. The presser foot will not raise after thread snips if Automatic presser foot lift has been deactivated in the Settings menu. Thread snips performed by the machine can be cancelled in the Settings menu. In embroidery mode the threads are cut and the presser foot raised. The upper thread is only cut automatically at WKHFRORUFKDQJH:KHQWKHGHVLJQLVÀQLVKHGERWKQHHGOH and bobbin threads are cut automatically. Preparations