Philips BDM4350UC User manual - Page 14

Remove the Base Assembly, for VESA Mounting

Get Philips BDM4350UC PDF manuals and user guides View all Philips BDM4350UC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

2. Setting up the Display B A (main) A (main) B Top-Left B A (main) Bottom-Left A (main) B • Swap: The main picture source and the sub picture source swapped on the display. Swap A and B source in [PIP] mode: B A (main) ↔ A B (main) • Off: Stop MultiView function. Note 1. When you do the SWAP function, the video and its audio source will swap at the same time. (Refer to page "Independent audio playback, regardless of video input" for more detail.) 2. When enable Multiview by interlace timing ( i-timing), the sub-windows display may flicker. Please change sub-window signal source to be progressive timing( P-timing). 2.4 Remove the Base Assembly for VESA Mounting Before you start disassembling the Display base, please follow the instructions below to avoid any possible damage or injury. 1. Place the Display face down on a smooth surface. Pay attention not to scratch or damage the screen. 2. Loosen the assembly screws, then detach the bases from the Display. 1 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
12
2. Setting up the Display
B
A
(main)
A
(main)
B
Top-Left
Bottom-Left
B
A
(main)
A
(main)
B
•
Swap
: The main picture source and
the sub picture source swapped on
the display.
Swap A and B source in [
PIP
] mode:
B
A
(main)
↔
B
(main)
A
•
Off
: Stop MultiView function.
Note
1. When you do the SWAP function,
the video and its audio source will
swap at the same time. (Refer to page
<7> “Independent audio playback,
regardless of video input” for more
detail.)
2. When enable Multiview by interlace
timing ( i-timing), the sub-windows
display may flicker.
Please change sub-window signal
source to be progressive timing(
P-timing).
2.4 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the
Display base, please follow the
instructions below to avoid any possible
damage or injury.
1.
Place the Display face down on a
smooth surface. Pay attention not
to scratch or damage the screen.
2. Loosen the assembly screws, then
detach the bases from the Display.
1