Philips FWP900 User manual - Page 21

English CD Operation Discs Playback To playback all discs on the disc tray G Press PLAYÉÅ. ➜ All the available discs will playback once and then stop. ➜ During playback, the selected disc tray, track number and elapsed playing time of the current track will appear on the display. To playback one disc only G Press the DISC DIRECT PLAY button : DISC 1, DISC 2 or DISC 3. ➜ The selected disc will playback once and then stop. To interrupt playback G Press PAUSEÉÅ. G To resume playback, press PLAYÉÅ again. To stop playback G Press Ç. To search for a particular passage during playback G Press and hold à or á and release it when the desired passage is located. ➜ During searching, the volume will be reduced. To select a desired track G Press í or ë repeatedly (or Digits 0-9 on the remote control) until the desired track appears on the display. G If in the stop position, press PLAYÉÅ to start playback. Note: - If in Shuffle mode, pressingí will cause the player skip only to the beginning of the current track. To skip to the beginning of the current track during playback G Press í once. Replace discs during playback 1 Press DISC CHANGE. 2 To change the inner disc, press DISC CHANGE again. ➜ "DISC CHANGE" will be displayed and the disc will stop playing. ➜ The disc tray will close to retrieve the inner disc and then open again with the inner disc accessible. Programming the disc tracks Programming tracks is possible when playback is stopped. Up to 40 tracks can be stored in the memory in any order. 1 Load the desired discs on the disc tray (refer to "Loading Discs"). 2 Press PROG to start programming. ➜ PROGRAM will start flashing. 3 Press CD (CD 1•2•3) or DISC 1/2/3 button to select a disc. 4 Press í or ë (or Digits 0-9 on the remote control) to select the desired track. 5 Press PROG to store the track. G Repeat steps 3-5 to store other discs and tracks. 6 Press PLAYÉÅto start program playback. ➜ "PLAY PROGRAM" will be displayed. G To end programming without playback, pressÇ once . ➜ The total number of tracks programmed and total playing time will appear on the display. Notes: - If the total playing time is more than "99:59" or if one of the programmed tracks has a number greater than 30, then "--:--" will appear on the display instead of the total playing time. - If you attempt to program more than 40 tracks, "PROGRAM FULL" will be displayed. - If you press any of the DISC DIRECT PLAY buttons, the system will playback the selected disc or track and the stored program will be ignored temporarily.The PROGRAM display also will disappear temporarily from the display. It will reappear when playback of the selected disc ends. - During programming, if no button is pressed within 20 seconds, the system will exit the Program mode automatically. pg 001-033/P900/37-Eng 21 21 12/8/00, 1:53 PM 3139 115 20411