Philips FWP900 User manual - Page 8

English General Information This system complies with the FCC rules, Part 15 and with 21 CFR 1040.10. Operation is subject to the following two conditions: - This device may not cause harmful interference, and - This device must accept any interference received, including interference that may cause undesired operation. Environmental Information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet). Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment. Acknowledgement Energy Star As an ENERGY STARR Partner; Philips has determined that this product meets the ENERGY STARR guidelines for energy efficiency. Dolby Manufactured under license from Dolby Laboratories."PRO-LOGIC" and the double-D symbol d are trademarks of Dolby Laboratories. Confidential unpublished works. C 1992-1997 Dolby Laboratories. All rights reser ved. Supplied accessories - Remote control - Batteries (two AA size) for remote control - AM loop antenna - FM wire antenna - AC power cord - CS-900 speaker package (includes one pair of surround speakers and one center speaker) - SW-900 powered subwoofer Safety Information G Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer. G Place the system on a flat, hard and stable surface. G Place the system in a location with adequate ventilation to prevent internal heat build-up in your system. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from each side. G Do not expose the system, batteries or discs to excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight. G If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the system. Should this occur, the CD player will not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible. G The mechanical parts of the set contain selflubricating bearings and must not be oiled or lubricated. G When the system is switched to Standby mode, it is still consuming some power. To disconnect the system from the power supply completely, remove the AC power plug from the wall socket. 8 pg 001-033/P900/37-Eng 8 12/8/00, 1:52 PM 3139 115 20411