Philips FWR3337 User manual - Page 11
Installation
View all Philips FWR3337 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
English Installation Speaker connections The speaker connections are click-fit connectors. Use them as shown below. 1 Connect the colored (or marked) wire to the red terminal and the black (or unmarked) wire to the black terminal. 2 Connect: - Left speaker to L (red and black) - Right speaker to R (red and black) Antenna connections AM antenna The supplied loop antenna is for indoor use only. 1 Fit the plug of the loop antenna to AM ANTENNA as shown below. 2 Position the antenna as far as possible from the TV, a VCR and other radiation sources. 3 Turn the antenna for optimum reception. AM ANTENNA FM ANTENNA FM antenna The supplied wire antenna can only be used to receive nearby stations. For better reception we recommend using a cable antenna system or an outdoor antenna. 1 Open the FM ANTENNA click-fits by pushing the lever down as shown below. 2 Insert each wire of the antenna into one hole. 3 Close the click-fits using the lever. 4 Move the antenna in different positions for optimum reception. ANTENNA FM ANTENNA AM ANTENNA FM ANTENNA Power The type plate is located on the rear of the unit. 1 Check whether the power voltage as shown on the type plate corresponds to your local power voltage. If it does not, consult your dealer or service organization. 2 Make sure all connections have been made before switching on the power supply. 3 Connect the supplied power cable to AC MAINS ~ and to the power outlet.This switches on the power supply. When the unit is switched to standby, it is still consuming some power. To disconnect the unit from the power completely, remove the power cable from the power outlet. To avoid overheating of the unit, a safety circuit has been built in.Therefore, your unit may disconnect under extreme conditions. If this happens, switch the unit off and let it cool down before reusing it. Plug and Play This function allows you to store all available radio stations automatically. First setup 1 When you switch on the power AUTO INSTALL - PRESS PLAY will be scrolled. 2 Press ÉÅ to start storing. ➜ INSTALL is displayed, followed by TUNER and AUTO. ➜ PROG starts flashing. ➜ All FM stations, followed by all other stations of other wavebands with sufficient signal strength, will be stored. Note: If no stereo signal is detected, CHECK ANTENNA will be displayed. Check the antenna connection or turn the antenna for optimum reception. 3 When all available radio stations are stored or the memory for 40 presets is full, storing will stop and the last stored radio station will play. 0 To exit automatic storing, press Ç. Note: If you exit automatic storing before completion, the function will restart when you switch on the power supply again. Restarting Plug and Play 1 Press ÉÅ for minimum 5 seconds in standby or demonstration mode. ➜ AUTO INSTALL - PRESS PLAY will be scrolled. 2 Press ÉÅ to restart storing. ➜ INSTALL is displayed, followed by TUNER and AUTO. ➜ PROG starts flashing. ➜ All previously stored stations will be replaced. 8