Philips FWR3337 User manual - Page 28

English DISPLAY CDR CD1 CD2 CLOCK•TIMER CD3 SOURCE TUNER AUX CD RECORDER CONTRJOOGL COPY CD COMPILE CD RECORD FINALIZE CD ERASE CDR OPEN•CLOSE MASTER VOLUME Tuning to radio stations 1 Press TUNER to select the tuner. ➜ TUNER is scrolled. 2 Press TUNER again to select the desired waveband. ➜ The selected waveband is displayed. 3 Keep à SEARCH or á SEARCH pressed for more than half a second. ➜ The selected waveband and SEARCHING are displayed. The radio tunes to a station with sufficient signal strength. 4 Repeat searching until you find the desired station. 0 To tune to a weak station, briefly press à SEARCH or á SEARCH as often as necessary for optimum reception. Storing radio stations It is possible to store up to 40 radio stations. Stations can be selected and programmed automatically or you can do that yourself. Programming will overwrite your former presets starting from the last active preset station. After programming the last preset stored will be tuned. Automatic programming If no preset is tuned, automatic programming starts at preset number 1. 1 Follow steps 1 and 2 of "Tuning to radio stations". 2 Keep PROG pressed for more than 2 seconds. ➜ AUTOPROGRAM is displayed and PROG is shown. ➜ All available radio stations for the selected waveband are stored automatically, PROG goes off, the preset number, the waveband and the frequency of the last preset station are displayed briefly. Tuner 0 To store radio stations for another waveband, repeat steps 1-2. Make sure to select the next available preset number first before proceeding, otherwise, already programmed radio stations may be erased. 0 To exit the automatic programming press Ç. Note: Strong stations always will automatically be programmed first, followed by the weak stations. Manual programming 1 Follow steps 1 and 2 of "Tuning to radio stations". 2 Keep PROG pressed for less than 2 seconds. ➜ PROG starts flashing. 3 Press à SEARCH or á SEARCH to tune to the desired radio station. 0 To allocate the radio station to another preset number, rotate í JOG CONTROL ë. 4 Press YES to confirm the setting and to exit the manual programming. ➜ PROG goes off, the preset number, the waveband and the frequency of the preset station are displayed. 0 To delete the current preset, press NO. Tuning to preset stations q Use í JOG CONTROL ë until the preset number of the desired station is displayed. 25