Philips HD8325 User manual - Page 16

4 INSTALLATION For your own and other people safety, follow the "Safety Regulations" indicated in Section 3 carefully. 4.1 Packaging The original packaging has been designed to protect the machine during shipping. We recommend keeping the packaging material for possible future transport. 4.2 Installation Instructions Before installing the machine, read the following safety instructions carefully: • Place the machine in a safe place; • Make sure children cannot play with the machine; • Do not place the machine on hot surfaces or near open flames. The coffee machine is now ready to be connected to the electrical network. Note: It is recommended to wash the components before using them for the first time and/or after they have not been used for a certain period of time. 4.3 Machine Connection Electric power may be very dangerous! It is therefore necessary to strictly follow the safety regulations. Do not use faulty power cords! Faulty cords and plugs must be replaced immediately in Authorised Service Centres. Fill the tank only with fresh, non-sparkling, drinking water. Hot water or any other liquid may damage the tank. Do not operate the machine if water is not present: Make sure there is enough water in the tank. • (Fig.3A) - Insert the water tank making sure that it has been properly repositioned in its former seat and then reposition the lid (2). After filling the water tank, place it back into the machine. Make sure that the tank is correctly inserted into the machine by pushing it firmly until its limit stop in order to avoid water leaks from the bottom - THE REFERENCE MARK INDICATED IN FIG. 3B SHOULD BE FULLY VISIBLE. 4.5 Circuit Priming At the beginning, after dispensing steam or when the water tank is empty, the machine's water circuit must be primed. • Press the ON/OFF button (11) and switch it to the "I" position. The light (18) will turn on to indicate that the machine is on. • (Fig.4) - Place a container under the steam wand (Pannarello). • Open the "hot water/steam" knob (3) by turning it counterclockwise. • (Fig.5) - Set the selection knob (17) to the " " position. • Wait until a steady jet of water flows out of the steam wand (Pannarello). • (Fig.5) - Set the selection knob (17) to the " " position. • Close the "hot water/steam" knob (3) by turning it clockwise. Remove the container. The voltage of the appliance has been pre-set by the manufacturer. Check that the voltage matches the indication on the data plate placed at the bottom of the appliance. • Check that the ON/OFF button (11) is set on "0" before connecting the machine to the electrical network. • Insert the plug into a wall socket with suitable power voltage. 4.6 Using the Machine for the First Time or after a Period of Inactivity This simple operation ensures optimum brewing and must be performed: - At first start-up; - When the machine remains inactive for a long time (more than 2 weeks). 4.4 Water Tank • (Fig.1A) - Remove the lid from the water tank (2) by lifting it. • (Fig.1B) - Remove the water tank (5). • (Fig.2) - Rinse and fill it with fresh drinking water taking care not to overfill. Dispensed water must be emptied into an adequate drain. It is not suitable for food use. If the container fills up during the cycle, stop dispensing water and empty the container before resuming the operation. • (Fig.2) - Rinse the tank and fill it again with fresh drinking water. • 16 •