Philips HU4805 User manual - Page 14

Cleaning the filter, Removing scale, Disinfecting the reservoir

Page 14 highlights

Removing scale 1 Switch off the humidifier and unplug from the electrical outlet. 2 Remove the upper unit by holding it at both sides (fig. c). 3 Remove filter and filter support from the reservoir (fig. p). 4 Empty reservoir. 5 Fill reservoir with 8oz./236.5ml undiluted white vinegar. Let solution sit in reservoir for 20 minutes (fig. s). 6 Clean all interior surfaces with a soft brush. Dampen soft cloth with undiluted white vinegar and wipe out reservoir to remove scale (fig. t). 7 Rinse thoroughly with clean, warm water to remove scale and cleaning solution before disinfecting the reservoir (fig. u). Disinfecting the reservoir 1 Follow the instructions for removing scale. 2 Place reservoir in a sink. Fill reservoir with a solution of 1 tsp/5g chlorine bleach in 1 gal/3.78liters water. Let solution stay 20 minutes, swishing every few minutes. Wet all surfaces (fig. v). 3 Empty reservoir and rinse with water until bleach smell is gone (fig. w). 4 Dry the inside and outside of the reservoir with a soft, clean cloth or paper towel (fig. x). 5 Put the filter and filter support back into the reservoir (fig. f). 6 Place the upper unit back onto the reservoir (fig. h). Cleaning the filter 1 Take out the filter and the filter support from the reservoir (fig. p). 2 Remove the filter from the filter support (fig. q). 3 Soak the filter in tap water for one hour (fig. r). 4 Rinse the filter under a slowly running tap water. (fig. y). 5 Let excess water drip off the filter. 6 Assemble the filter around the filter support (fig. e). 7 Put the filter and the filter support back into the reservoir (fig. f). 8 Put the upper unit back onto the reservoir (fig. h). Note • Do not squeeze or wring the filter. This might damage the filter and impact the humidifier's performance. • Do not dry the filter under direct sunlight. 12 EN

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38

12
EN
Cleaning the filter
1
Take out the filter and the filter
support from the reservoir (fig.
p
).
2
Remove the filter from the filter
support (fig.
q
).
3
Soak the filter in tap water for one
hour (fig.
r
).
4
Rinse the filter under a slowly
running tap water. (fig.
y
).
5
Let excess water drip off the filter.
6
Assemble the filter around the filter
support (fig.
e
).
7
Put the filter and the filter support
back into the reservoir (fig.
f
).
8
Put the upper unit back onto the
reservoir (fig.
h
).
Note
Do not squeeze or wring the filter. This
might damage the filter and impact the
humidifier’s performance.
Do not dry the filter under direct
sunlight.
Removing scale
1
Switch off the humidifier and unplug
from the electrical outlet.
2
Remove the upper unit by holding it
at both sides (fig.
c
).
3
Remove filter and filter support from
the reservoir (fig.
p
).
4
Empty reservoir.
5
Fill reservoir with 8oz./236.5ml
undiluted white vinegar. Let solution
sit in reservoir for 20 minutes
(fig.
s
).
6
Clean all interior surfaces with
a soft brush. Dampen soft cloth
with undiluted white vinegar and
wipe out reservoir to remove scale
(fig.
t
).
7
Rinse thoroughly with clean, warm
water to remove scale and cleaning
solution before disinfecting the
reservoir (fig.
u
).
Disinfecting the reservoir
1
Follow the instructions for removing
scale.
2
Place reservoir in a sink. Fill reservoir
with a solution of 1 tsp/5g chlorine
bleach in 1 gal/3.78liters water. Let
solution stay 20 minutes, swishing
every few minutes. Wet all surfaces
(fig.
v
).
3
Empty reservoir and rinse with water
until bleach smell is gone (fig.
w
).
4
Dry the inside and outside of the
reservoir with a soft, clean cloth or
paper towel (fig.
x
).
5
Put the filter and filter support back
into the reservoir (fig.
f
).
6
Place the upper unit back onto the
reservoir (fig.
h
).