Philips LX800037 User manual - Page 13

English Inserting batteries into the remote control 1 Open the battery compartment. 2 Place the batteries in the compartment with the correct polarity as indicated by "+" and "-" symbols. 3 Close the cover. CAUTION! - Remove batteries if they are exhausted or will not be used for a long time. - Do not use old and new or different types of batteries in combination. - Batteries contain chemical substances, so they should be disposed off properly. Switching on the system 1 After completing all the connections, connect the AC power cord of the DVD system and subwoofer to the power outlet. q The first time you turn on power, "AUTO INSTALL - PRESS PLAY" may appear on the display screen. PressÉÅ on the system to start installation or press Ç to exit (refer to "Radio Reception Plug and Play"). 2 Press SOURCE button (or press TV/AV, DISC, TUNER or AUX/DI) to select the input source. ➜ The selected source will be displayed. q For viewing a DVD or VCD, a TV needs to be connected (refer to "Connections - Connecting a TV"). Switch on the TV and set it to the correct video in channel (for example, EXT1, EXT2, AV1, AV2). Refer to your TV instruction manual for details. ➜ The default screen appears on the TV. q You can connect other equipment to the DVD system in order to use the Home Cinema Audio System's surround sound capabilities. For example, connect to a TV and select TV/AV as the input source or connect to a VCR and select AUX as the input source. IMPORTANT! - If your TV screen is only showing a black/white picture or the picture is completely distorted, please refer to "NTSC/PAL setting" or "System Setup (DVD) - TV system". - If you do not get a proper picture or sound, please refer to "System Setup (DVD)" in order to change the pre-settings as necessary to accommodate your TV system or change to your preferred settings. NTSC/PAL setting Set the DVD system to NTSC or PAL, whichever matches your TV. The factory default setting is NTSC. This setting is necessary if you connected the DVD system to a PAL TV only. 1 Press SOURCE or DISC to select disc mode. ➜ Make sure that no disc is inside the disc tray. 2 Hold down DISC on the remote control until the current setting (NTSC or PAL) appear on the display.  3 If you want to change the setting, repeat step 2. PREPARATIONS 13