Philips MCW770 User manual - Page 47

English Tuner Tuning to radio stations CD TUNER AUX PC LINK CD1 CD2 CD3 CD4 CD5 VOL ALBUM BROWSE REPEAT PROGRAM SHUFFLE DISPLAY 1 Press SOURCE on the unit repeatedly or press TUNER on the remote control repeatedly until the desired waveband (TUNER FM or TUNER AM) is displayed. 2 Press and hold 4 or ¢ for more than a half second, then release. ➜ The unit automatically tunes to the next station with sufficient signal strength. ➜ = lights up when receiving a stereo signal (in FM waveband only). 3 Repeat step 2 until you find the desired station. 0 To tune to a station with a weak signal press 4 or ¢ briefly and repeatedly until an optimal reception is found. Storing radio stations You can store up to 40 radio stations in the memory, starting from FM and followed by AM wavebands. Stations can be stored automatically or manually, or by using the "Plug and Play" function. If no button is pressed within 20 seconds the unit will exit from the storing mode. Storing by using "Plug and Play" You can store all available radio stations automatically. Attention:All previously stored radio stations will be replaced. 1 Connect the unit to the power supply. ➜ TUNER and AUTO INSTALL - PRESS PLAY are displayed. or In standby mode press and hold ÉÅ on the unit until TUNER and AUTO INSTALL PRESS PLAY are displayed. 2 Press ÉÅ on the unit to start the installation. ➜ TUNER INSTALL is displayed and automatic searching and storing starts. ➜ During searching TUNER AUTO is displayed. ➜ As soon as a radio station is found and stored the frequency and the waveband will be displayed. ➜ Once completed, the last tuned radio station will be played. Note: If no stereo signal is detected CHECK ANTENNA is displayed. 28