Philips SCD520 User manual - Page 13

ENGLISH 13 5 Leave the parent unit in the charger until the battery pack is fully charged. , During charging, the charging light on the charger lights up continuously. , When the battery pack is fully charged, the display of the parent unit shows a full battery symbol T. - When you charge the parent unit for the first time or after a long period of disuse, switch it off and let it charge continuously for at least 10 hours. - Charging normally takes 8 hours, but it takes longer when the parent unit is switched on while charging.To keep the charging time as short as possible, switch off the parent unit during charging. - When the battery pack is fully charged, the parent unit can be used cordlessly for at least 24 hours. Note:When the parent unit is charged for the first time, the operating time is less than 24 hours.The battery pack only reaches its full capacity after you have charged and discharged it four times. Note:When the parent unit is not connected to a power outlet or even when the parent unit is switched off, the battery pack gradually discharges. Using the appliance Use the baby monitor for its intended household use as described in this manual. 1 Place the parent unit and the baby unit in the same room to test the connection. Make sure the baby unit is at least 3 feet/1 meter away from the parent unit. 2 Press and hold the on/off button 3 on the baby unit until the green power-on light goes on. Note:The power-on light always lights up green, even when there is no connection with the parent unit. , The nightlight lights up briefly and then goes out again. , The battery light T lights up briefly and then goes out again.