Philips SCD520 User manual - Page 23

ENGLISH 23 Warranty FULL TWO YEAR WARRANTY Philips Electronics North America Corporation (USA) and Philips Electronics Ltd (CANADA) warrant each new Philips AVENT product, model SCD520/00, against defects in materials or workmanship for a period of two years from the date of purchase, and agrees to repair or replace any defective product without charge. IMPORTANT:This warranty does not cover damage resulting from accident, misuse or abuse, lack of reasonable care, or the affixing of any attachment not provided with the product. NO RESPONSIBILITY IS ASSUMED FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES. In order to obtain warranty service, simply call toll-free 1-800-54-AVENT. Frequently asked questions This chapter lists the questions most frequently asked about the appliance. If you cannot find the answer to your question, call 1-800-54-AVENT (1800-542-8368) for assistance. Question Answer Why don't both the poweron light of the baby unit and the LINK light of the parent unit come on when I press the on/off buttons of the units? Why does the LINK light on the parent unit light up red continuously and why is the message 'Not Linked' shown on the display? Why does the battery light on the baby unit flash red? Perhaps the battery pack of the parent unit are empty and the parent unit is not in the plugged-in charger. Insert the small appliance plug into the charger, put the adapter of the charger in a wall socket and place the parent unit in the charger.Then press the on/off button to establish connection with the baby unit. Perhaps the non-rechargeable batteries of the baby unit are empty and the baby unit is not connected to an electrical outlet. Replace the nonrechargeable batteries or connect the baby unit to an electrical outlet. Then press the on/off button to establish connection with the parent unit. The baby unit and the parent unit may be out of range of each other. Move the parent unit closer to the baby unit, but not closer than 3 feet/1 meter. If the LINK light on the parent unit still does not start to flash, use the reset function to reset the units to their default settings. The baby unit and the parent unit are out of range of each other. Move the parent unit closer to the baby unit. The baby unit may be switched off. Switch on the baby unit. The non-rechargeable batteries of the baby unit are running low. Replace the non-rechargeable batteries or connect the baby unit to an electrical outlet (see chapter 'Preparing for use').