Philips SRP2004WM User manual - Page 6

of TV/VCR,TV/VCR/DVD - universal remote codes

Get Philips SRP2004WM PDF manuals and user guides View all Philips SRP2004WM manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

CBL/SAT VCR Cable box, satellite receiver, Internet Protocol TV (IPTV), Free To Air TV, High Definition Television decoder (HDTV) and Tivo Video cassette player / recorder, Personal video recorder (PVR),VCR part of TV/VCR, TV/VCR/DVD and VCR/DVD combos Example: setting up the universal remote control to operate your TV: 1 Switch ON the TV manually or use the original remote control for this. Tune to channel 1. 2 Press and hold the 5 sec. device selection key for 5 seconds until the red Setup light remains lit . The remote control is now in setup mode. 3 Look up the 4-digit code for your brand in the brand list at the back of this user manual. A 4-digit code is shown for each brand. Use the digit keys to enter the code for your brand (e.g. Philips, ). • If the red Setup light turns off, an invalid code was entered. In this case, t5r-60ySEC.again. 4 Aim the remote 5 - 60 sec. control at the TV. Press and hold the key. Release it immediately as soon the TV switches off. •This step normally takes between 5 and 60 seconds. In extreme circumstances this step can take up to 15 minutes. 6 EN WM_17__Manual_80_210.indd 6 25-09-0

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
6
EN
CBL/SAT
Cable box, satellite
receiver, Internet Protocol
TV (IPTV), FreeTo AirTV,
High DefinitionTelevision
decoder (HDTV) and Tivo
VCR
Video cassette player /
recorder, Personal video
recorder (PVR),VCR part
of TV/VCR,TV/VCR/DVD
and VCR/DVD combos
Example: setting up the universal remote
control to operate your TV:
1
Switch ON
the TV manually or use the
original remote control for this. Tune to
channel 1.
2
Press and hold
the
device selection
key
for 5 seconds
until the red Setup
light
remains lit .
The remote control
is now in setup mode.
3
Look up the 4-digit
code for your brand
in the
brand list
at
the back of this user
manual.
A 4-digit code is
shown for each brand.
Use the digit keys
to enter the code
for your brand
(e.g. Philips,
).
•
If the red Setup
light
turns off, an invalid code was
entered. In this case, try again.
4
Aim the remote
control at theTV.
Press and hold
the
key. Release it
immediately
as soon
the TV switches off.
•This step normally takes between
5 and 60 seconds. In extreme
circumstances this step can take up to
15 minutes.
5 sec.
5 - 60 sec.
WM_17__Manual_80_210.indd
6
25-09-0