Pioneer 210 Owner's Manual - Page 5
Locating the Center of the Display, Mounting Bracket Positioning
UPC - 770680021090
View all Pioneer 210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
PWM-T210 Locating the Center of the Display CAUTION: Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could result in serious personal injury and possible damage to the flat panel. WARNING: INVERT THE FLAT PANEL PLACE IT ON A SOFT, FLAT SURFACE TO PREVENT DAMAGE TO THE FLAT PANEL. USE A BLANKET, FOAM, ETC. FAILURE TO DO SO WILL RESULT IN DAMAGING THE FLAT PANEL. DO NOT LAY THE FLAT PANEL ON THE FLOOR WITHOUT ANY PROTECTION TO THE GLASS. THE FLAT PANEL IS HEAVY AND FRAGILE. AT LEAST (2) QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR INSTALLATION OF THIS PRODUCT. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE TO THE FLAT PANEL. Tape Measure Inverted Display Display Top Display CL Bottom Figure 1 1. Once the flat panel is inverted, use a measuring tape to find the center of your flat panel measuring from outside to outside of the chassis (Figure 1). Mounting Bracket Positioning Marking the Center of the Display Inverted Display CL Figure 2 2. Using a pencil lightly mark the center of your flat panel (Figure 2). Display Bottom Left Mounting Bracket Right Mounting Bracket Arrows Facing Out Figure 3 3. Lay the left and right mounting brackets over the mounting points, with the stamped arrows facing out (Figure 3). Installation Instructions Page 5