Pioneer 210 Owner's Manual - Page 6

PWM-T210 Display CL Bottom Align the Mounting Brackets Display Bottom Center of Display Mounting Bracket Viewing Guide Center Figure 4 4. Match the center of viewing guide with the center line you marked in step 1 (Figure 4). Figure 5 5. The mounting brackets are designed with a center of viewing guide on the side of them (Figure 5). Securing the Mounting Brackets The Griplates™ have M4, M5, M6 and M8 hole patterns to fit the hardware that your flat panel requires. NOTE: Your plasma uses M8 x 20 or M6 x 12 Phillips screws, use the M8, or M6, mounting points. 1. Once the mounting brackets are aligned secure the Griplate™ to the flat panel (Figure 6). NOTE: The dimples of the top plates have to be facing up and the bottom dimples must be facing down. 2. Pre-install two (2) M6 x 30 (mm) Phillips pan screws to the bottom of the left and right hand side mounting brackets. Screwdriver M4 M5 M6 M8 DIMPLES FACING UP DIMPLES FACING UP DIMPLES FACING DOWN Display Bottom DIMPLES FACING DOWN Page 6 Figure 6 Installation Instructions