Pioneer 210 Owner's Manual - Page 8

Securing the Lower Wall Plate Level Wall Plate Wall Plate PWM-T210 Marked Wall Template Figure 11 1. Level and secure the plate to the wall with the reference arrow facing up to the ceiling (Figure 11). 2. Secure the plate using the provided lag bolts and washers. Securing the Upper Wall Plate Wall Marks Wall Plates Figure 13 1. Drill four (4) ¼" pilot holes in the marked wall (Figure 13). These pilot holes will be for the upper mounting bracket. Page 8 Figure 12 3. When the bottom wall plate is properly installed to the wall. 4. Lay the carton template on top of the wall plate. 5. Lay the top wall plate on top of the cardboard template and mark the four (4) mounting points (Figure 12). Power Source Area Wall Plates Figure 14 2. Level and secure the plate to the wall with the reference arrow facing up to the ceiling. 3. Secure the plate using the provided lag bolts (Figure 14). CAUTION: Do not over tighten the mounting hardware. NOTE: CHECK THE MOUNT FOR PROPER TIGHTNESS AND SECURITY. Installation Instructions