Pioneer 210 Owner's Manual - Page 7
Marking the Wall, Marking the Bottom Mounting Points
UPC - 770680021090
View all Pioneer 210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
PWM-T210 Marking the Wall Viewing Port Center Mark the Wall Wall Structure CENTER OF VIEWING HEIGHT DESIRED VIEWING PORTS CENTER OF VIEWING LINE MARKING THE LINE Figure 7 1. Align the center viewing port from the carton template to the wall. Match the center of viewing port to the center of viewing height desired (Figure 7). Figure 8 2. Mark a line on the bottom of the carton template (Figure 8). Marking the Bottom Mounting Points CAUTION: The lag bolts must be secured to the center of a stud. Use a commercially available stud finder to locate the studs nearest to your center viewing mark. Pilot Holes Drill Gun 16" Wall Plate Level Mounting Slots Wall Structure Figure 9 1. Place the upper portion of the bottom wall plate to the reference line and mark the four (4) lag bolt mounting points through the wall plate slots on the wall (Figure 9). 2. Level the wall plate with the reference arrow pointing up to the ceiling. Installation Instructions Figure 10 3. Pilot holes are recommended. Use a 1/4" drill bit to drill where your markings are located (Figure 10). These pilot holes will be for the lower mounting plate. Page 7