Pioneer AVH-P6400CD Operation Manual - Page 15

Power ON/OFF Section 02 English Español Deutsch Français Turning the unit on 1 Turn your vehicle's engine ON. The display will be automatically deployed by the automatic close/open mode. If the display is not automatically deployed, press OPEN/CLOSE. 2 Press SOURCE to select the tuner. Press SOURCE until you see Tuner displayed. Closing the Display Turn the vehicle's engine OFF. - When the ignition switch is turned ON again (or turned to ACC), the display will be deployed automatically. - Installing the operation panel will automatically deploy the display. (Refer to page 11.) • The automatic close/open mode can be switched ON/OFF. (Refer to page 63.) • When the ignition switch is turned OFF after the display has been closed, turning the ignition switch ON again (or turning it to ACC) will not deploy the display. In this case, press OPEN/CLOSE to deploy the display. Screen Angle Adjustment The angle of this product's screen continues changing as long as you keep pressing the ANGLE button. Adjust the screen to an easily viewable angle. TEXT The display will be automatically closed by the automatic close/open mode. If the display does not close automatically, turn the ignition switch ON again (or turning it to ACC) and press OPEN/CLOSE. Notes • The automatic close/open mode will operate the display as follows. - When the ignition switch is turned OFF while the display is deployed, the display will be closed after approximately 6 seconds. Important • If you can hear the display knocking against your vehicle's console or dashboard, press ANGLE on the (-) side to move the screen a little forward. Notes • When adjusting the angle, be sure to press ANGLE. Forcible adjusting of the display by hand may damage it. • The adjusted angle of the display will be memorized and automatically returned to the next time the display is deployed. En 15 Italiano Nederlands