Pioneer AVIC Z1 Owner's Manual - Page 179
Appendix - wiring
UPC - 012562813219
View all Pioneer AVIC Z1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 179 highlights
Appendix Appendix Appendix The navigation system may not be You cannot position your vehicle mounted securely in your vehicle. on the map without a significant positioning error. The navigation system is installed with an extreme angle exceeding the installation angle limitations. Check that the navigation system is securely mounted and, if necessary, consult the dealer that installed the system. Confirm the installation angle. (The navigation system must be installed within the allowed installation angle. For details, refer to "Installation Manual".) Indication of the position of your vehicle is misaligned after a U-turn or reversing. Check whether or not the reverse gear signal input lead (violet) is connected properly. (The navigation system works properly without the lead connected, but positioning accuracy will be adversely affected.) The map color does not switch automatically between daytime and nighttime. [Day/Night Display] is set to [Day]. Check [Day/Night Display] setting and make sure [Automatic] is selected. (Page 46) The orange/white lead is not connected. Check the connection. The screen is too bright. An improper value has been set on Check the settings. (Page 158) "Brightness". The display is very dim. The vehicle's light is turned ON, and Read about [Day/Night Display] setting and, [Automatic] is selected on [Day/ if desired, select [Day]. (Page 46) Night Display]. An improper value has been set on Check the settings. (Page 158) "Brightness". No sounds of AV source are pro- The volume level is low. duced. The volume level will not rise. The attenuator or mute is on. A speaker lead is disconnected. Adjust the volume level. Turn the attenuator or mute off. Check the connection. The volume of navigation gui- Try to adjust them with VOL (+/-) dance and beeps cannot be ad- button. justed. Turn the volume up or down using [Volume] on the "System Settings" menu. (Page 98) The person on the other end of the phone call cannot hear the conversation due to an echo. There's no picture. "Rear display" picture disappears. The voice from the person on the Use the following methods to reduce the other end of the phone call is output echo: from the speakers and then picked -Lower the volume on the receiver up by the microphone again, creat- -Have both parties pause slightly before ing an echo. speaking The parking brake cord is not con- Connect the parking brake cord, and apply nected. the parking brake. The parking brake is not applied. Connect the parking brake cord, and apply the parking brake. The backlight of the LCD panel is turned off. Turn on the backlight. (Page 102) The source disc being listened to in Before ejecting the disc, switch the source. the navigation system has been This problem may occur when certain con- ejected. nection methods are used. There is a problem with the "Rear Check the "Rear display" and its connection. display", for example a faulty wiring connection. An AV source that cannot output to Select an appropriate AV source. the rear display is selected. En 179