Pioneer AVIC Z3 Other Manual - Page 14
Connecting the power cord 2, Connecting the System - car speed signal input
UPC - 012562888613
View all Pioneer AVIC Z3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Section 02 Connecting the System Connecting the power cord (2) Speed detection circuit lead Vehicle injection computer Connector 5 m (16 ft. 5 in.) Pink (CAR SPEED SIGNAL INPUT) The mobile navigation system is connected here to detect the distance the vehicle travels. Always connect the vehicle´s speed detection circuit or the ND-PG1 speed pulse generator, sold separately. Failure to make this connection will increase errors in the location display. Connection method Pass the extension cord and the lead for the speed detection circuit through this hole. Clamp firmly with needlenosed pliers. WARNING IMPROPER CONNECTION MAY RESULT IN SERIOUS DAMAGE OR INJURY INCLUDING ELECTRICAL SHOCK, AND INTERFERENCE WITH THE OPERATION OF THE VEHICLE´S ANTILOCK BRAKING SYSTEM, AUTOMATIC TRANSMISSION AND SPEEDMETER INDICATION. CAUTION · It is strongly suggested that the speed pulse wire be connected for accuracy of navigation and better performance of interlock. · If the speed pulse wire is unavailable for some reason, it is recommended that the pulse generator (ND-PG1) be used. Note Close the cover. The position of the speed detection circuit and the position of the parking brake switch vary depending on the vehicle model. For details, consult your authorized Pioneer dealer or an installation professional. Light green Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch. If this connection is made incorrectly or omitted, certain functions of your navigation system will be unusable. WARNING LIGHT GREEN LEAD AT POWER CONNECTOR IS DESIGNED TO DETECT PARKED STATUS AND MUST BE CONNECTED TO THE POWER SUPPLY SIDE OF THE PARKING BRAKE SWITCH. IMPROPER CONNECTION OR USE OF THIS LEAD MAY VIOLATE APPLICABLE LAW AND MAY RESULT IN SERIOUS INJURY OR DAMAGE. Connection method Clamp the parking brake switch power supply side lead. Clamp firmly with needle-nosed pliers. Power supply side Ground side Parking brake switch 14 En