Pioneer AVIC Z3 Other Manual - Page 30

After Installing this, Navigation System, After Installation

Get Pioneer AVIC Z3 - Navigation System With DVD player PDF manuals and user guides
UPC - 012562888613
View all Pioneer AVIC Z3 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Section 04 After Installation After Installing this Navigation System 1 Reconnecting the battery. First, double-check that all connections are correct and that this product is installed correctly. Reassemble all vehicle components that you previously removed. Then reconnect the negative (-) cable to the negative (-) terminal of the battery. 2 Start the engine. 3 Press RESET button. Press RESET button on the navigation unit using a pointed object such as the tip of a pen. 4 Enter the following settings: 1 Make any necessary installation angle adjustments. (Refer to the operation manual.) 2 Change [Regional Settings] if necessary. (Refer to the operation manual.) 3 Drive until the initialized sensors start operating normally. Set the navigation system as explained in the operation manual or hardware manual. Note After installing this navigation system, be sure to check at a safe place that the vehicle is performing normally. 30 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
After Installing this
Navigation System
1
Reconnecting the battery.
First, double-check that all connections are
correct and that this product is installed cor-
rectly. Reassemble all vehicle components
that you previously removed. Then reconnect
the negative (
–
) cable to the negative (
–
) term-
inal of the battery.
2
Start the engine.
3
Press RESET button.
Press
RESET
button on the navigation unit
using a pointed object such as the tip of a
pen.
4
Enter the following settings:
1
Make any necessary installation angle ad-
justments. (Refer to the operation manual.)
2
Change [
Regional Settings
] if necessary.
(Refer to the operation manual.)
3
Drive until the initialized sensors start oper-
ating normally.
Set the navigation system as explained in the
operation manual or hardware manual.
Note
After installing this navigation system, be sure to
check at a safe place that the vehicle is perform-
ing normally.
After Installation
En
30
Section
04