Pioneer AVIC Z3 Other Manual - Page 22

Before installing, Installing this navigation, system, Installation - wiring

Page 22 highlights

Section 03 Installation ! GPS antenna and its lead In addition you should lay or route each antenna lead as far as possible from other antenna leads. Do not bind them together, lay or route them together, or cross them. Such electromagnetic noise will increase the potential for errors in the location display. Before installing ! Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. ! Before making a final installation of this product, temporarily connect the wiring to confirm that the connections are correct and the system works properly. ! Do not install this navigation system in a position where the opening of the LCD panel is obstructed by any obstacles, such as the shift lever. Before installing this navigation system, be sure to leave sufficient space so that the LCD panel does not obstruct the shift lever when it is fully opened. This may cause interference with the shift lever, or a malfunction of the mechanism of this navigation system. ! Install this navigation system in an area strong enough to bear its weight. Choose a position where this navigation system can be firmly installed, and install it securely. If this navigation system is not securely installed, the current location of the vehicle cannot be displayed correctly. ! Install the navigation unit horizontally on a surface within 0 degrees to 30 degrees tolerance. If the installation angles on the left and right sides exceed 5 degrees, the allowable range can be increased to 10 degrees by making corrective adjustments. (Refer to the operation manual.) If connection of the pink lead CAR SPEED SIGNAL INPUT is omitted, the angles on the left and right sides are allowable to within 5 degrees. Improper installation of the unit with the surface tilted more than these tolerances increases the potential for errors in the location display, and might otherwise cause reduced display performance. Installing this navigation system Installation notes ! Do not install this navigation system in places where it may become subject to high temperatures or humidity, such as: - Places close to a heater, vent or air conditioner. - Places exposed to direct sunlight, such as on top of the dashboard. - Places that may be splashed by rain, for example close to the door. If the angle exceeds 5 degrees, please make corrective adjustments. 22 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59

!
GPS antenna and its lead
In addition you should lay or route each anten-
na lead as far as possible from other antenna
leads. Do not bind them together, lay or route
them together, or cross them. Such electro-
magnetic noise will increase the potential for
errors in the location display.
Before installing
!
Consult with your nearest dealer if installa-
tion requires the drilling of holes or other
modifications of the vehicle.
!
Before making a final installation of this
product, temporarily connect the wiring to
confirm that the connections are correct
and the system works properly.
!
Do not install this navigation system in a
position where the opening of the LCD
panel is obstructed by any obstacles, such
as the shift lever. Before installing this navi-
gation system, be sure to leave sufficient
space so that the LCD panel does not ob-
struct the shift lever when it is fully opened.
This may cause interference with the shift
lever, or a malfunction of the mechanism of
this navigation system.
Installing this navigation
system
Installation notes
!
Do not install this navigation system in
places where it may become subject to
high temperatures or humidity, such as:
Places close to a heater, vent or air con-
ditioner.
Places exposed to direct sunlight, such
as on top of the dashboard.
Places that may be splashed by rain, for
example close to the door.
!
Install this navigation system in an area
strong enough to bear its weight. Choose a
position where this navigation system can
be firmly installed, and install it securely. If
this navigation system is not securely in-
stalled, the current location of the vehicle
cannot be displayed correctly.
!
Install the navigation unit horizontally on a
surface within 0 degrees to 30 degrees tol-
erance. If the installation angles on the left
and right sides exceed 5 degrees, the allow-
able range can be increased to 10 degrees
by making corrective adjustments. (Refer to
the operation manual.) If connection of the
pink lead CAR SPEED SIGNAL INPUT is
omitted, the angles on the left and right
sides are allowable to within 5 degrees. Im-
proper installation of the unit with the sur-
face tilted more than these tolerances
increases the potential for errors in the lo-
cation display, and might otherwise cause
reduced display performance.
If the angle exceeds 5 degrees,
please make corrective adjust-
ments.
Installation
En
22
Section
03