Pioneer CNDV-50MTP Operation Manual - Page 71

Messages and how to react to them The following messages may be displayed by your Navigation System. ❒ There are occasions when you may see error messages other than those shown here. In such a case, follow the instructions given on the display. Message You cannot use this function while driving. Please insert the appropriate disc. This is not the appropriate disc. Please insert the appropriate disc. Irregular speed pulse signal is detected. Please power off the system and check the installation. After you have checked, please re-boot the system and press "OK". Speed pulse wire is not connected. System will start to learn without speed pulse. Please keep in mind that accuracy is not fully ensured without speed pulse. Vibration is detected. Please power off the system and check the installation. After you have checked, please re-boot the system and press "OK". Direction of G sensor is not correct. Please power off the system and check the installation. After you have checked, please re-boot the system and press "OK". Gyro Sensor is not working properly. Please consult your dealer or Pioneer service center. System detected that the vertical angle of the installation has been changed. Learning status for Gyro Sensor has been initialized. System detected that the vertical angle of the installation exceeds the permission level.Please install the navigation unit correctly. When While trying to make a menu selection. • If you try to use a disc which is incompatible with this system. • If you insert a disc upside down. • If the disc is dirty. • If the disc is cracked or otherwise damaged. If the Navigation unit does not receive the vehicle speed pulse. The speed signal input (pink lead wire) of the power cable is not connected. While the vehicle is stationary, the Navigation System is installed in a place where the navigation unit may be affected by a large vibration. Direction of G sensor is set incorrectly. Abnormal output of Gyrosensor is detected. In case the mounting angle of the navigation unit is changed. The navigation unit is installed with an extreme angle exceeding the limitation of the installation angle. What to do Pull over and come safely to a halt, put the parking brake on, and then try again. • Insert a suitable disc. • Insert the disc with the label upward. • Clean the disc. • Insert a normal, round disc. Consult your Pioneer dealer. To operate with 3D hybrid mode, connect the speed signal input (pink lead wire) of the power cable correctly. Although it can be operated with Simple hybrid mode without connecting the speed signal input, the precision of the positioning will be less accurate. Re-install the navigation unit of the Navigation System in a place where the navigation unit will not be affected by vibration. See the "Installation Manual" and set the direction of G sensor correctly. Note down the error code shown on the screen; turn off the power, and then contact your nearest Pioneer service facility. The system initializes the sensor in order to operate it with the maximum performance and automatically starts re-learning. Check the installation position of the navigation unit of your Navigation System and the setting of the Installation direction lever (➞ "Installation Manual"). If time data has been lost it cannot be saved to the PC Card. If this message is displayed, the built-in battery of the navigation unit might be running out. Confirm the installation angle. (The navigation system must be installed within +30 degrees to -15 degrees of the horizontal, or within five degrees of your vehicle's direction of travel.) • Check that the GPS aerial is correctly connected. • Consult the Pioneer Local dealer if this message persists. Appendix 69