Pioneer CT-W616DR Operating Instructions - Page 10
Forward
View all Pioneer CT-W616DR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
I FRONT PANEL FACILITIES OPERATION OF DECK [ WITH A REMOTE I CONTROL UNIT NOT DESIGNED FOR h DOUBLE DECKS (System remote control) I Selecting DECK [ In order to operate DECK [ with the remote control unit, adjust the unit as follows: With the power off, press and hold the stop (m) button of DECK l, and turn the power on. Continue to hold the stop (1) button for approximately five seconds. DECK ] can now be operated using the remote control unit, but DECK ]l cannot. Switching to DECK ][ To restore remote control operation to DECK 11,press the stop (m) button of DECK II while DECK II is in stop mode. DECK 11can now be operated using the remote control unit. Remote control operation can be switched back and forth between decks by pressing the stop button of the desired DECK while it is in stop mode, NOTE: ff a power failure or a sudden change in the power supply (caused by lightning, etc.) occurs, the unit is reset to its original state. Only DECK II can be ol_rated by remote control To restore operation to either deck, repeat the above procedure from the beginning. FUNCTION DISPLAY (_) DECK ! counter indicator Normally the tape counter or time counter is displayed (see page 11). It flashes for 4 seconds after the power cord is connected to the power supply. (_ CD.DECK SYNCHRO indicator (CD SYNC) This indicator lights steadily when the CD SYNC button is pressed and the operation starts. (_ FLEX Indicator (Except for U.S. model of CT- W606DRI This indicator lights when the FLEX button is pressed. _) DECK ]1 counter indicator Normally the tape counter or time counter is displayed (see page 11). It flashes for 4 seconds after the power cord is connected to the power supply. (_ DECK I] tape transport mode indicators See table entitled "TAPE TRANSPORTATION MODE INDICA- TORS" on this page. (_ DECK [I AUTO BLE XD indicator model of CT-W606DR) (Except for U.S. • See page 13. (_) DOLBY NR BIC indicator (_ Level meter Holds peak for about 1.3 seconds. The "e" mark beside the 0 dB mark indicates the Dolby NR system standard level. (_) Reverse mode indicator (_ DECK ! tape transport mode indicators See table entitled "TAPE TRANSPORTATION MODE INDICATORS" on this page. 10 En TAPE TRANSPORTATION MODE INDICATORS I PI.AY _1_ < PI-AyREC _I_ These indicators display the current tape transport mode. The chart below shows the meaning of each of these indicators. The indicators for DECK ] and DECK [1 differ only in the location of the PLAY and REC indicators (DECK l-left, DECK ll-right). For both DECK ] and ]1 Forward mode Stop _1_ _:ZZFIla:s_hing rapidly Reverse mode Playback Fast forward PI.Ay _ ._ play ,.*J, ,_lf. Fast reverse _-_'_ _ _ _'DI_ Fmuosicrwseaarrcdh _ ,,\ g /.. , ,_ ,qJ, - - ._._.., Rmeuvseicrsseearch P.._.. .Y.(- _1_ 41 - l.=...l..Ay _ -_,,:.- DECK II only Playback pause Recording Recording standby muteRecording Forward mode E_ Flashing slowly Reverse mode PLAY _ _ PLAy IR_=C _1_ _ RmC REC _ _ RISC _ I_ 41_