Pioneer CT-W616DR Operating Instructions - Page 2
Important, Safety Instructions
View all Pioneer CT-W616DR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
IMPORTANT 2 FOR USE IN THE UNITED KINGDOM l_w wire _ thfa mm_l hind m _mrmd _ accordan_ wah the foaowi_l oede : blul _1 brown live If the plug provided is unsuizadld for your socket outlets, the plug must be cut off and a suitable plug fitted The cut-off plug should be disposed of and must not be insertad into any 13 amp socket as this can result in Elec- tric shock. The plug or adaptor or the distribution panel should be provided with 5 amp fuse. AS the coldurs of the wires in the mains lead of this appliance may not COL respond with coioured markings ldent_ying the terminals in your plug, proceed as follows : The wire which is coioured blue must be connected to the terminal which is marked with the is_ler N or coioured black¸ The wire which is coloured brown must be connected to the terminal whioh is marked with the letter L or coloured red Do not corm4_'t_ther wire to the earth terminalof • three pin plug NOTE After redisbing or changing • fuse, the fuse cover in the plug must be replaced with • fuse cover which Gorrespends to the coldur of the insert in the bese ef the plug or the word that is embossed on the base of the plug, and the appliance must not be used without a fuse cover¸ If lost replacement fuse covers can be obtained from: your Pealer¸ Only 5 A fuses approved by B.SI. 1362 should be used or A ST A to 88 IMPORTANT SAFETY INSTRUCTIONS READ INSTRUCTIONS -- All the safety and operating instructions should be read before the product is opecated RETAIN INSTRUCTIONS -- The safety and operating instructions should be retained for future reference¸ HEED WARNINGS -- All warnings on the Weduct and in the operating instructions should be adhered Io FOLLOW INSl_UCTIONS w All operating and use _nst ructions should be followed¸ CLEANING m The product shc_ld be cleaned only with e polishing cloth or a soft dry cloth. Never oleen with fumlture wax, benzine, insecticides or other volabie liquids since they may corrode the cabinet. ATTACHMENTS -- Do not use eflachments not recommended by the product manofacturer as they may cause hazards¸ WATER AND MOISTURE -- DO not use this product near weter m for example, near a bathtub, wash bowl, kitchen sir)k, or laundrytub;in a wet basement; or near a swimmLng pool; and the like¸ ACCESSORIES -- DO not place this p_educt on an unstable cart. stand, tribixL bracket or table. The product may fall causing serious ldiury to a child or adult, and serious damage to the product¸ Use only with • cart, stand, tripod, bracket, or table recommended by the manufacturer, or sold with the product Any mounting of the product should follow the manefactufer's _nstructions, and should use a mounting accessory recommended by the manufacturer. CART -- A product and cart combination should be moved with care. Ou_ck stops, excessive force, and uneven surfaces may cause'the product and cart combination to overturn. VIENllLA11ON -- Slots and openings in the cabinet are provided for ventilation and to ensure rbilabie operation of the product and to protect it from overheating, and these openings must not be blocked or covered¸ The openings should never be blocked by placldg the product on a bed, sofa, rug, or other simiisr surface¸ TNS product should not be placed in a buil_in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to POM_R SOURCES m This product should be operated only from the type of power source indicated on tEe marking label If you are not sure of the type of power suPPly to your home, consolt your product dealer or local power coml_ny LOCATION - The appliance should be installed in a stable location¸ NONUSe PERIDIDG - The power corg of the appliance should be unplugged from the outlet when left unused for e long period of t_me GROUNDING OR POLARIZATION • If this product is equipped with a polarized alternating current line plug (a plug having One blade wider than the othed, it will fit into the outlet only one way. This is a safety feature.If yc.J are unabld toinsert the p_ug fully into the outlet, try ieversing the plug¸ If the plug should still fai_ to fit. contact your electrlo_ln To replace your obsolete outlet¸ DO not defeat the safety purpose of the pola¢ized plug • If this product is equipped with a three-wire grounding type plug, e plug having a third (grounding) pin, it willooly fit into a grounding typa power outlet This laa sofety feature If you are unable to insert the plug into the outlet, contact your electrleisn to replace your obsolete outlet. Do not defeat the safety purpose of the grounding type plug¸ POWER-CORD PROTECTION -- Power-supply cords should be routed so that they are not likely to be walked on or pir_ched by items placed upon or against them, paying pertlcular attention to cords at pings, convenience receptaclds, and the point whore they exit from the product. OU1OOOR ANTENNA GROUNDING -- If an outside entennaorcablesystemlaconnectedtotheproduct. be sure the antenna Or cable system is grounded so as to provlde some protection egeinst veflage surges and built-up static charges Article 810ef the National Ele:t ncal Code, AN SI/N F PA 70. provipe sirdor matldn with regard to proper grounding of the mast and supporting structure, grounding of the leaden wire to an antenna discharge unit, size of grounding conductors, location of antennzPdischarge unit, ¢onnectiofl to grounding electrodes, and requirementsforthegmundingelectrode SeeFigure A LIGHTNING D For added protection for this product during a lightning storm, or when it isldft unattended and unused for long periods of time. unplug it from the wall outlet and disConnect the antenna or cable system. This will prevent damage to the product due to lightning and power*line surges¸ POWER UEIES m An outside antenr_ system should not beldcatad in the vicinityof overheed power lines or other electric light or power circuits, or where it can fag into such power lines Or circufbi When installing an outside arttenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal. OVERLOADING m Do not overload waft oupets, exle nsion cords, or intngral corlve nience fete ptades as this can result in a risk of fire or electric shock¸ GROUND CLAMP OBJECT AND LIQDID ENTRY -- Ne vet push objects of any kind into this product through openings as they may touch dangerous voltage points Or short-out parts that could result in a fire or electric shock¸ Never spill liquid of any kind on the product. RERVlClNG -- DO not attempt to serv_e this product yourself as opening or removing covers may expose you to dangerous w_tage Or other hazards¸ Refer all SeT_ cing to qualified service personnel DAMAGE REQUIRING SERVICE -- Un pingthis preduc! from the waft outlet and refer servicing to qual_fldd service personnel under the folldw_ng conditions: • When the power-supply cord or plug is damaged¸ • If liquid has been spilled, or objects have fallen _nto the product. • If the preduct has been exposed to rain or water¸ • If the preduet does not operate normally by folldwing the operating instructions.Adjust o_ly those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualrilad technician to restore the product to its normal operation • If the product has been dro_pad or damaged in any way. • When the product exhibits a distinct change in pedormance -- this indicates • need for setvise REPLACEMENT PARTS _ When replacement parts are required, be sure the set_e technician has used replacement parts specified by the manufacturer or have the same characleristios as the original pa_ Unauthorized substitutions may result inere, electric shock, or other hazards¸ SAFE'W CHECK -- Upon completion of any sewioe or repairs to this product, ask the service technician to perform safety checks todefarmlde that the product is in proper operating condition¸ WALL OR CEILING MOUNTING w The product should not be mounted to a weft or ceiling HEAT m The product should be situated away from heat sou(ces such as radistocs, heat registers, stoves, or other products {including amplifiers) that produce heat¸ ANTENNA f LEAD IN WIRE ELECTRIC SERVICE Fig. A _(NEC GROUNSDE{CNTGION CO81N0D-2UOCITORS (NEC SECllON 810-21) _"- GROUND CLAMPS -- POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEe ART 250, PART H) NEe -- NATIONAL ELECTRICAL CODE CONDENSATION When thisunitisbroughtintoa warm room from previouslycoldsurroundingsorwhen the room temperaturerisessharplyc,ondensationmay I form insidea,nd theunitmay not be ableto attainitsfullperformance.To preventthis,allowthe unittostand forabout an hour beforeswitchingiton, or raise the room temperature gradua y. 2