Pioneer DEH-P700BT Owner's Manual - Page 31

Operating this unit Section 02 Operating this unit # If the connection fails, ERROR is displayed. In this case, check the cellular phone and try again. # If three cellular phones have already been paired, the pairing assignment selection display will appear. Select one assignment to pair the new phone. The newly paired phone overwrites the previously paired phone. The assignment selection operation is the same as Step 3 to 4 of Pairing a connected cellular phone on this page except for the operation below. ! Switching the BD address and device name 8 Use MULTI-CONTROL to decide to download the phone book from your cellular phone or not. Push MULTI-CONTROL left or right to select NO (No) or YES (Yes). Press MULTI-CONTROL to decide. When you select YES, this unit changes to PH BOOK DOWNLOAD and the download operation automatically begins. After completing, DATA DOWNLOADED is displayed. According to the circumstances, this unit changes to PH BOOK TRANSFER. In this case, refer to step 4 on Transferring entries to the phone book on page 39. # When you select NO, the display reverts to normal. Connecting a paired cellular phone 1 Display the connection menu. Refer to Introduction of connection and registration on page 29. 2 Turn MULTI-CONTROL to select PAIRED PHONE. # Push MULTI-CONTROL up or down to select a desired phone. # Push MULTI-CONTROL left or right to switch the device name, BD address, group name and group ID. 3 Press MULTI-CONTROL to start connection. While connecting, CONNECTING is displayed. If the connection is established, CONNECTED is displayed. After connected, this unit automatically changes to PH. BOOK DL (phone book download confirmation) display. # If the connection fails, ERROR is displayed. In this case, check the cellular phone and try again. 4 Use MULTI-CONTROL to decide to download the phone book from your cellular phone or not. Push MULTI-CONTROL left or right to select NO (No) or YES (Yes). Press MULTI-CONTROL to decide. When you select YES, this unit changes to PH BOOK DOWNLOAD and the download operation automatically begins. After completing, DATA DOWNLOADED is displayed. # When you select NO, the display reverts to normal. Disconnecting a cellular phone 1 Display the connection menu. Refer to Introduction of connection and registration on page 29. 2 Use MULTI-CONTROL to select DISCONNECT PHONE. 3 Press MULTI-CONTROL to disconnect a cellular phone from this unit. After disconnection is completed, DISCONNECTED is displayed. Pairing a connected cellular phone Pairing is usually performed automatically during the connection operation. You only need to perform this operation manually when your phone is connected temporarily for any reason. We recommend you pair the phone to this unit to make best use of the technology. 1 Display the connection menu. Refer to Introduction of connection and registration on page 29. 2 Use MULTI-CONTROL to select SET PHONE. En 31