Pioneer DEH-P7800MP Owner's Manual - Page 60
Using the equalizer, Audio Adjustments, Recalling equalizer curves
UPC - 012562793917
View all Pioneer DEH-P7800MP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Section 13 Audio Adjustments 2 Push MULTI-CONTROL left or right to select slope. Each time MULTI-CONTROL is pushed left or right, slopes are selected in the following order: -12- -6-Pass (0) (dB/oct.) # If you set the slope to 0 dB/oct. (Pass), the audio signal bypasses the filter, so the filter does not have an effect. 3 Turn MULTI-CONTROL to select Rear HPF FREQ. Rear HPF FREQ. appears in the display. 4 Push MULTI-CONTROL left or right to select cut-off frequency. Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order: 50-63-80-100-125-160-200 (Hz) Only frequencies higher than those in the selected range are output from the rear speakers. 5 Push MULTI-CONTROL up or down to adjust the output level of the rear speakers. Each time MULTI-CONTROL is pushed up or down, the level of the rear speakers increases or decreases. 0 to -24 is displayed as the level is increased or decreased. Using the equalizer The equalizer lets you adjust the equalization to match car interior acoustic characteristics as desired. Recalling equalizer curves There are seven stored equalizer curves which you can easily recall at any time. Here is a list of the equalizer curves: Display Equalizer curve Powerful Powerful Natural Natural Vocal Vocal Flat Flat Custom1 Custom 1 Custom2 Custom 2 Super Bass Super bass ! Custom1 and Custom2 are adjusted equalizer curves that you create. Adjustments can be made with a 16-band graphic equalizer. ! When Flat is selected no supplement or correction is made to the sound. This is useful to check the effect of the equalizer curves by switching alternatively between Flat and a set equalizer curve. % Press EQ to select the equalizer. Press EQ repeatedly to switch between the following equalizers: Powerful-Natural-Vocal-Flat-Custom1 -Custom2-Super Bass Adjusting equalizer curves The factory supplied equalizer curves, with the exception of Flat, can be adjusted to a fine degree (nuance control). 1 Use MULTI-CONTROL to select the graphic equalizer adjustment. Powerful appears in the display. # If the equalizer curve has been previously selected, the curve of that previously selected will be displayed instead of Powerful. 2 Push MULTI-CONTROL left or right to select an equalizer curve. Each time MULTI-CONTROL is pushed left or right, equalizer curves are selected in the following order: 60 En