Pioneer DEH-P980BT Owner's Manual - Page 102
Understanding built-in CD, player error messages, Understanding auto TA and, EQ error messages, - problems
UPC - 012562793948
View all Pioneer DEH-P980BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Appendix Additional Information Understanding built-in CD player error messages When you contact your dealer or your nearest Pioneer Service Center, be sure to record the error message. Message Cause Action ERROR-11, 12, Dirty disc 17, 30 Clean disc. ERROR-11, 12, Scratched disc Replace disc. 17, 30 ERROR-10, 11, Electrical or me12, 15, 17, 30, chanical A0 Turn the ignition ON and OFF, or switch to a different source, then back to the CD player. ERROR-15 The inserted disc Replace disc. does not contain any data ERROR-23 The CD format Replace disc. cannot be played back NO AUDIO The inserted disc Replace disc. does not contain any files that can be played back Track Skipped The inserted disc contains WMA files that are protected by DRM Replace disc. PROTECT All the files on the inserted disc are secured by DRM Replace disc. pears, refer to the table below to see what the problem is and the suggested method of correcting the problem. After checking, try again. Message Cause Action Check MIC type Microphone is Disconnect the miconnected to mi- crophone. crophone input. MIC ERROR Microphone is not connected. Plug the supplied microphone securely into the jack. Front Speaker The microphone ! Confirm that the ERROR, Front cannot pick up speakers are con- left Speaker the measuring nected correctly. ERROR, Front tone of a speaker. ! Cancel muting right Speaker the front speaker ERROR, Rear units. left Speaker ! Correct the input ERROR, Rear level setting of the right Speaker power amp con- ERROR, Sub- nected to the woofer speakers. ERROR, Sub- ! Set the micro- woofer Lch phone correctly. ERROR, Sub- woofer Rch ERROR Noise ERROR The surrounding noise level is too high. ! Stop your car in a place that is as quiet as possible, and switch off the engine, air conditioner or heater. ! Set the microphone correctly. Understanding auto TA and EQ error messages When correct measurement of car interior acoustic characteristics is not possible using the auto TA and EQ, an error message may appear on the display. If an error message ap- 102 En