Pioneer FH-X720BT Owner's Manual - Page 16

Menu Item PLAY STOP OPERATE MODE [CHANNEL], [REPLAY] TUNE MIX [ON], [OFF] TUNE SCAN TUNE START [ON], [OFF] PARENTAL CTRL [LOCKED CH] [CLEAR ALL] [EDIT CODE] AUDIO settings Menu Item FADER*1*2 BALANCE 16 En Description Start playback. Stop playback. Assign or buttons to select a channel or skip backward/skip forward. Create a music channel that's a blend of songs made up from the music channels stored on the current band of presets. Scan through songs from your music channel presets. Start playback of the broadcast from the beginning of a song when tuning to a preset music channel. Lock the currently played channel that contains mature content. Unlock all the channels that are restricted to access. Change the passcode. The default passcode is [0000]. Description Adjust the front and rear speaker balance. Adjust the left and right speaker balance. Menu Item Description EQ SETTING [SUPER BASS], [POWERFUL], [NATURAL], [VOCAL], [CUSTOM1], [CUSTOM2], [FLAT] Select an equalizer band and level for further customizing. Equalizer band: [80HZ], [250HZ], [800HZ], [2.5KHZ], [8KHZ] Equalizer level: [+6] to [-6] Select or customize the equalizer curve. [CUSTOM1] can be set separately for each source. However, each of the below combinations are set to the same setting automatically. • USB, iPod, PANDORA (iPhone), and APP (iPhone) • BT AUDIO, PANDORA (Android), and APP (Android) [CUSTOM2] is a shared setting used for all sources. LOUDNESS [OFF], [LOW], [MID], [HI] Compensate for clear sound at low volume. SUB.W*3*4 [NOR], [REV], [OFF] Select the subwoofer phase. SUB.W CTRL*3*4*5 Cut-off frequency: [50HZ], [63HZ], [80HZ], [100HZ], [125HZ], [160HZ], [200HZ] Output level: [-24] to [+6] Slope level: [-12], [-24] BASS BOOST [0] to [+6] Only frequencies lower than those in the selected range are output from the subwoofer. Select the bass boost level. HPF SETTING Cut-off frequency: [OFF], [50HZ], [63HZ], [80HZ], [100HZ], [125HZ], [160HZ], [200HZ] Slope level: [-12], [-24] Only frequencies higher than the high-pass filter (HPF) cutoff are output from the speakers. SLA [+4] to [-4] Adjust the volume level for each source except FM. Each of the below combinations are set to the same setting automatically. • USB, iPod, PANDORA (iPhone), and APP (iPhone) • BT AUDIO, PANDORA (Android), and APP (Android) *1 Not available when [SW] is selected in [REAR-SP] in the INITIAL settings (page 7). *2 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 7).