Pioneer MVH-P8300BT Owner's Manual - Page 16

Section 03 Operating this unit Storing the tag information to this unit 1 Tune in to the broadcast station. 2 Press and hold M.C. if appears in the display while the desired song is broadcasting. Storing the tagged information to your iPod 1 Connect the iPod to this unit and transfer this unit's tag information to the iPod. ! The tagged songs and the song that you can buy from the iTunes Store may be different. Make sure to confirm the song before you make the purchase. ! If you cannot use this function normally, update your iPod firmware. ! The tag information for up to 50 songs can be stored on this unit. Depending on the timing of when the tag information is stored, the tag information for the song played before or after the currently playing song may also be stored. ! If an SD is selected as the source while tag information is being stored to this unit, the tag information will not be transferred to the iPod. ! Tag information cannot be transferred to the iPod when a file on an SD device is being viewed as a slideshow. ! While transferring the tag, you cannot select the SD source. Local (local seek tuning) Local seek tuning lets you tune in to only those radio stations with sufficiently strong signals for good reception. 1 Press M.C. to display the setting mode. 2 Turn M.C. to select the desired setting. FM: Off-Level1-Level2-Level3-Level4 AM: Off-Level1-Level2 The highest level setting allows reception of only the strongest stations, while lower levels allow the reception of weaker stations. 3 Press M.C. to confirm the selection. Function settings 1 Press M.C. to display the function menu. 2 Turn M.C. to select the function. After selecting, perform the following procedures to set the function. BSM (best stations memory) BSM (best stations memory) automatically stores the six strongest stations in the order of their signal strength. 1 Press M.C. to turn BSM on. To cancel, press M.C. again. 16 En