Pioneer MVH-P8300BT Owner's Manual - Page 50
Understanding auto EQ, error messages, Indicator list, Additional information
UPC - 884938124348
View all Pioneer MVH-P8300BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Appendix Additional information iTunes tagging Message Cause Action iPod full. Tags not transferred. Memory used for tag information on the iPod is full. Sync the iPod with iTunes and clean up the tagged playlist. Memory full. Tags not stored. This unit's flash memory used as the temporary storage area is full. Connect the iPod to this unit and transfer this unit's tag information to the iPod. Tag transfer failed. Reconnect your iPod. This unit's tag in- Check the iPod formation cannot and try again. transfer to the iPod. Tag store failed. Tag information Try again. cannot be stored in this unit. SD source can- Tag information not be se- is being trans- lected during ferred to the tag transfer. iPod. Wait until tag transfer is complete. Bluetooth Telephone Message Cause Action Error-10 The power failed for the Bluetooth module of this unit. Turn the ignition switch OFF and then to ACC or ON. If the error message is still displayed after performing the above action, please contact your dealer or an authorized Pioneer Service Station. Understanding auto EQ error messages When correct measurement of the car's interior acoustic characteristics is not possible using auto EQ, an error message may appear on the display. In such cases, refer to the table below to see what the problem is and how it may be corrected. After checking, try again. Message Cause Action Error. Please check MIC. The microphone Plug the optional is not connected. microphone se- curely into the jack. Error. Please check xxxx speaker. The microphone ! Confirm that the cannot pick up speakers are conthe measuring nected correctly. tone of a speaker. ! Correct the input level setting of the power amp connected to the speakers. ! Set the microphone correctly. Error. Please check noise. The surrounding noise level is too high. ! Stop your car in a place that is quiet, and switch off the engine, air conditioner and heater. ! Set the microphone correctly. Error. Please check battery. Power is not being supplied from the battery to this unit. ! Stop your car in a place that is quiet, and switch off the engine, air conditioner and heater. ! Connect the battery correctly. Indicator list Common (MVH-P8300BT only) Indicates that a Bluetooth telephone is connected. (MVH-P8300BT only) Indicates the signal strength of the cellular phone. Shows when tag information is stored in this unit. Flashes when the tag is being transferred to an iPod. 50 En