Pioneer PDA-5004 Operating Instructions - Page 16

English Installation and Connections Connection to INPUT2 A computer equipped with DVI output (digital RGB signal) can be connected to the plasma display's DVI connector. DIGITAL RGB DVI-D INPUT2 AUDIO Personal computer On-screen setup is necessary after connection. Please see pages 18 to 20. Notes ¶ Use a DVI-D 24-pin (digital only) cable for the connection. ¶ This unit does not support the display of copyguard- protected video signals. NOTICE ¶ INPUT2 is compatible with Microsoft's Plug & Play (VESA DDC 2B). ¶ For the screen sizes and input signals that INPUT2 is compatible with, please refer to the plasma display's Operating Instructions. Connection to INPUT3 Connect an AV component that has S-video output jack to the video card's S-VIDEO (INPUT3) jack. S-VIDEO INPUT3 Connection to INPUT4 Connect an AV component that has a video output jack to the video card's INPUT4 jack. The VIDEO OUT (INPUT4) jack can be used to output the video signal to a separate monitor, recording device or other component with video input capability. Note A video signal will not be output from the VIDEO OUT (INPUT4) jack when the main power of this display is off or in standby mode. [When using PDA-5003] VIDEO INPUT4 IN OUT To a monitor or a recording device [When using PDA-5004] VIDEO INPUT4 IN OUT AV component To a monitor or a recording device Installation and Connections AV component AV component Signals to the INPUT3 and INPUT4 jacks are all compatible with the following TV systems: NTSC, PAL, SECAM, 4.43NTSC, PAL M and PAL N. For details, please refer to "Setting the COLOR SYSTEM" on page 39. 13 En