Pioneer PDA-5004 Operating Instructions - Page 23

System Settings English System Settings 7 When a component other than a computer is connected, use the 5/∞ buttons to select [COLOR DECODING] (INPUT1 or INPUT5). MENU INPUT1 PICTURE SCREEN SETUP OPTION AUTO POWER OFF COLOR TEMP. DNR MPEG NR CTI PURECINEMA COLOR DECODING CLAMP POSITION SIGNAL FORMAT : DISABLE : MIDDLE : MIDDLE : LOW : ON : OFF : RGB : AUTO : VGA 8 Press the SET button repeatedly to select the input signal format. Selection will change as follows each time the SET button is pressed: 3 RGB 3 COMPONENT1 COMPONENT22 The table below shows what settings are appropriate and available for the type of connections made. Set [SIGNAL FORMAT] and [COLOR DECODING] as follows. Please take care when making settings. Incorrect settings can adversely affect the plasma display. Connected component SETUP SIGNAL FORMAT COLOR DECODING Component video output of a DVD player, etc. Component video output from digital tuner, etc. RGB video output of a video deck etc., with RGB output RGB video output of a PC 525p 750p 525p VGA, WVGA, 720-PC, XGA, WXGA, SXGA, SXGA+ COMPONENT1 COMPONENT2 RGB Not supported 9 When the setup is completed, press MENU to exit the menu screen. Notes ÷ Make this [SIGNAL FORAMT] setting for each applicable input (INPUT1, INPUT2 or INPUT5). ÷ Make [COLOR DECODING] settings individually for INPUT 1 or INPUT 5. ÷ The [COLOR DECODING] setting is not supported when inputting a computer signal, or when the [SIGNAL FORMAT] function has been used to select a signal other than [525p] or [750p]. 20 En [CLAMP POSITION] setup Depending on the signal, analog RGB signals may result in the screen image appearing with a whitish or greenish cast. In such cases, set [CLAMP POSITION] to [LOCKED]. Normally, leave this setting at [AUTO]. MENU 5/∞ 2/3 SET MENU 2/3 SET 5/∞ Display operating panel Remote control unit 1 Press the MENU button to display the menu screen. MENU PICTURE SCREEN CONTRAST : BRIGHTNESS : R.LEVEL : G.LEVEL : B.LEVEL : H.ENHANCE : V. E N H A N C E : SETUP 0 0 0 0 0 0 0 INPUT1 OPTION PICTURE RESET 2 Use the 2/3 buttons to select [SETUP]. MENU INPUT1 PICTURE SCREEN SETUP OPTION POWER MANAGEMENT CLAMP POSITION SIGNAL FORMAT : OFF : AUTO : VGA 3 Use the 5/∞ buttons to select [CLAMP POSITION]. MENU INPUT1 PICTURE SCREEN SETUP OPTION POWER MANAGEMENT CLAMP POSITION SIGNAL FORMAT : OFF : AUTO : VGA 4 Press the SET button to select [LOCKED]. MENU INPUT1 PICTURE SCREEN SETUP OPTION POWER MANAGEMENT CLAMP POSITION SIGNAL FORMAT : OFF : LOCKED : VGA The factory default setting is [AUTO]. Mode selection will change as follows each time the SET button is pressed: 3 AUTO LOCKED 2 5 When the setup is completed, press the MENU button to exit the menu screen. Notes ÷ Make this [CLAMP POSITION] setting for each applicable input (PDA-5003: INPUT1 or INPUT5, PDA-5004: INPUT1). ÷ When using this setup, be sure to carefully check the signal output of the component that you are using. For details, please refer to the instruction manual supplied with the component you are connecting.