Pioneer PDA-5004 Operating Instructions - Page 29

English Operation Automatic power-off (POWER MANAGEMENT) The plasma display is equipped with [POWER MANAGEMENT] and [AUTO POWER OFF] functions; when set, the function automatically switches the unit to either standby mode or power off mode whenever a sync signal is not detected (a warning message is displayed on the screen before the functions operate). Notes ÷ [POWER MANAGEMENT] settings are supported only when a computer signal is input to INPUT 1 or INPUT 5 (PDA-5003 only), or when INPUT2 is selected. ÷ The auto-power-off function can be used only in those cases other than the inputs used in the preceding item. ÷ Always turn off the plasma display's main power switch when not using the display for extended periods of time. INPUT MENU INPUT 2/3 SET MENU 2/3 SET Display operating panel Remote control unit 1 Press the MENU button to display the menu screen. MENU PICTURE SCREEN CONTRAST : BRIGHTNESS : R.LEVEL : G.LEVEL : B.LEVEL : H.ENHANCE : V. E N H A N C E : SETUP 0 0 0 0 0 0 0 INPUT1 OPTION PICTURE RESET 2 Use the 2/3 buttons to select [SETUP]. [When computer signal is input to INPUT1 or INPUT5 (PDA-5003 only), or when INPUT2 is used] MENU INPUT1 PICTURE SCREEN SETUP OPTION POWER MANAGEMENT CLAMP POSITION SIGNAL FORMAT : OFF : AUTO : VGA [In all other cases] MENU PICTURE SCREEN AUTO POWER OFF COLOR TEMP. DNR MPEG NR CTI PURECINEMA COLOR SYSTEM INPUT3 SETUP OPTION : DISABLE : MIDDLE : MIDDLE : LOW : ON : OFF : AUTO SET CHANGE MENU EXIT 3 Press the SET button to confirm selection of the [POWER MANAGEMENT] or [AUTO POWER OFF]. The factory default setting is [OFF/DISABLE]. Each time the button is pressed, the setting alternates as follows: 3 OFF/DISABLE ON/ENABLE 2 ÷ OFF/DISABLE..... The display will continue in operating mode, regardless of the presence/absence of an input sync signal. ÷ POWER MANAGEMENT: ON..... If a sync signal is not detected, a warning message is first displayed for 8 seconds, after which the display automatically enters the standby mode, and the ON indicator flashes green. If a sync signal (*1) is input again later, the plasma display automatically returns to normal operating mode. *1 Except when input signal is G ON SYNC or composite SYNC. ÷ AUTO POWER OFF: ENABLE..... If no sync signal is detected for 8 minutes or more, a warning message will be displayed for 30 seconds, after which the display's power will switch to power off mode. 4 When the setup is finished, press the MENU button to exit the menu screen. Note The [POWER MANAGEMENT] and [AUTO POWER OFF] functions must be set individually for each input (INPUT1 to INPUT5). To return to operating mode: ÷ To return to normal operation from the [POWER MANAGEMENT] function's standby mode, either operate your computer, or press the INPUT button on the plasma display or remote control unit. ÷ To return to normal operation from the [AUTO POWER OFF] function's power off condition, press the STANDBY/ ON button on the plasma display or on the remote control unit. Operation 26 En