Pioneer PDP-425CMX User Manual - Page 16

Installation and Connections English Installation and Connections Installation of the unit Installation using the supplied display stands Be sure to fix the supplied stands to the installation surface. Use commercially available M8 bolts that are 25 mm (1 in.) longer than the thickness of the installation surface. 1 Fix the supplied stands to the installation surface at each of the 4 prepared holes using commercially available M8 bolts. Front 517 mm (20-3/8 in.) (Bolt hole thread pitch) Rear Always install the supplied display stands according to the dimensions shown in the accompanying illustration. 110 mm (4-5/16 in.) 2 Set this unit in the stands. 3 Fix this unit using the supplied washer and bolt. CAUTION Use a 6 mm (1/4 in.) hex wrench to bolt them. This display unit weighs at least 30 kg (67 lbs) and has little front- to-back depth, making it very unstable when stood on edge. As a result, two or more persons should cooperate when unpacking, moving, or installing the display. 10 En Installation using the optional PIONEER stand or installation bracket ÷ Please be sure to request installation or mounting of this unit or the installation bracket by an installation specialist or the dealer where purchased. ÷ When installing, be sure to use the bolts provided with the stand or installation bracket. ÷ For details concerning installation, please refer to the instruction manual provided with the stand or installation bracket. Installation using accessories other than the PIONEER stand or installation bracket (sold separately) ÷ When possible, please install using parts and accessories manufactured by PIONEER. PIONEER will not be held responsible for accident or damage caused by the use of parts and accessories manufactured by other companies. ÷ For custom installation, please consult the dealer where the unit was purchased, or a qualified installer. Wall-mount installation of the unit This unit has been designed with bolt holes for wall-mount installation, etc. The installation holes provided are shown in the accompanying illustration. ÷ Be sure to attach in 4 or more locations above and below, left and right of the center line. ÷ Use bolts that are long enough to be inserted 12 mm (1/2 in.) to 18 mm (11/16 in.) into the main unit from the attaching surface for both a holes and b holes. Refer to the side view diagram in the accompanying illustration. ÷ As this unit is constructed with glass, be sure to install it on a flat, unwarped surface. CAUTION To avoid malfunction, overheating of this unit, and possible fire hazard, make sure that the vents on the main unit are not blocked when installing. Also, as hot air is expelled from the air vents, be careful of deterioration and dirt build up on rear surface wall, etc.. CAUTION Please be sure to use an M8 (Pitch = 1.25 mm) bolt. (Only this size bolt can be used.) CAUTION This display unit weighs at least 30 kg (67 lbs) and has little frontto-back depth, making it very unstable when stood on edge. As a result, two or more persons should cooperate when unpacking, moving, or installing the display. CAUTION This unit incorporates a thin design. To ensure safety if vibrated or shaken, please be sure to take measures to prevent the unit from tipping over.