Pioneer PDP-425CMX User Manual - Page 19

English Français Audio connections Before making connections, be sure to check that the audio component's power and the unit's main power is off. Connecting the speakers This unit is equipped with speaker output terminals for connection to the speaker system (not supplied) specially designed for use with this unit. Refer to the illustrations below when making connections to the speaker terminals on this unit. 12 mm Twist exposed wire strands together. Push tab to the open position, and insert the wire. Then, close tab firmly to secure the wire in place. Notes ÷ After connecting the wires, pull gently on the cables to confirm that the wire cores are fastened securely in their terminals. Insecure connections will result in noise or interrupted sound. ÷ Do not allow the wire cores of the ª and · speaker cables to protrude excessively, since they may touch each other, causing a short circuit. This will produce excessive load on the Plasma Display, causing operation to malfunction or stop. Connection to audio output connector Use a stereo miniplug to connect the Plasma Display's AUDIO (OUTPUT) stereo mini jack (L/R) to an AV amplifier or other component. OUTPUT INPUT1 INPUT2 AUDIO AUDIO AUDIO Installation and Connections Audio connections for component (computer) connected to INPUT1 OUTPUT INPUT1 INPUT2 AUDIO AUDIO AUDIO A stereo miniplug cable can be used to connect the audio output from the component connected to INPUT1, to the Plasma Display's AUDIO (INPUT1) stereo mini jack (L/R). Sound is output from both the AUDIO (OUTPUT) stereo mini jack (L/R) and the SPEAKER (L/R) terminals according to the video input selection. Audio connections for component (computer) connected to INPUT2 OUTPUT INPUT1 INPUT2 AUDIO AUDIO AUDIO Installation and Connections Making connections to the audio inputs on this unit This unit features two audio inputs and one audio output. The following chart shows the video inputs and the corresponding audio input terminals. Video input Audio input jacks Sound output INPUT1 INPUT2 Stereo mini jack (L/R) Stereo mini jack (L/R) Sound of the selected video input is output from the • SPEAKER (L/R) terminals • Stereo mini jack (L/R) A stereo miniplug cable can be used to connect the audio output from the component connected to INPUT2, to the Plasma Display's AUDIO (INPUT2) stereo mini jack (L/R). Sound is output from both the AUDIO (OUTPUT) stereo mini jack (L/R) and the SPEAKER (L/R) terminals according to the video input selection. 13 En