Pioneer PRS-D2000SPL Owner's Manual - Page 8
Connection Diagram
![]() |
UPC - 012562858937
View all Pioneer PRS-D2000SPL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Connecting the Unit Connection Diagram • In the case of connecting the external output from a car stereo to an RCA input, use the jack used for fullrange output. This is because the LPF of the amplifier cannot be turned OFF. If this jack cannot be used, connect the subwoofer output jack to the RCA input. The maximum length of the wire between the fuse and the positive (+) terminal of the battery is 45 cm. Grommet Ground wire, Terminal (sold separately) The ground wires must be same size as the battery wire. Connect to metal body or chassis. Battery wire (sold separately) Positive (+) For the wire size, see the terminal Negative (-) "Connecting the Power Terminal" terminal section. The battery wire, the ground wire and the optional direct Battery ground wire must be same size. After making all other connections Fuse (300 A) at the amplifier, connect the bat- Each amplifier must be SEPA- tery wire terminal of the amplifier RATELY fused at 300 A. to the positive (+) terminal of the battery. Jack for the bass boost remote control Connect this jack and the bass boost remote control with the bass boost remote control wire. SYNC OUTPUT/SYNC INPUT jack See the "Connecting the Speaker Wires" section for SYNC OUTPUT/SYNC INPUT jack connection instructions. Connecting wire with RCA pin plugs (sold separately). Car stereo with RCA output jacks External Output Bass Boost Remote Control 6 m (19 ft. 8 in.) RCA input jack Bass Boost Remote Control Wire Reverse side Speaker output terminal See the "Connecting the Speaker Wires" section for speaker connection instructions. Fuse (40 A) Fuse (40 A) System remote control wire (sold separately) Connect the male terminal of this wire to the system remote control terminal of the car stereo (SYSTEM REMOTE CONTROL). The female terminal can be connected to the auto-antenna relay control terminal. If the car stereo does not have a system remote control terminal, connect the male terminal to the power terminal through the ignition switch. 7
![](/manual_guide/products/pioneer-prsd2000spl-owners-manual-53b8f6b/8.png)