Pioneer SDV-P7 Other Manual - Page 1
Pioneer SDV-P7 - DVD Player - in-dash Manual
View all Pioneer SDV-P7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
INSTALLATION MANUAL OF OF SDV-P7 This product conforms to CEMA cord colors. Le code de couleur des câbles utilisé pour ce produit est conforme à CEMA. Printed in Japan Imprimé au Japon UC N STAR N STAR MANUEL D'INSTALLATION Connecting the Units Note: • This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a recreational vehicle, truck, or bus, check the battery voltage. • To avoid shorts in the electrical system, be sure to disconnect the ≠ battery cable before beginning installation. • Refer to the owner's manual for details on connecting the power amp and other units, then make connections correctly. • Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. • Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body. • Don't pass the yellow lead through a hole into the engine compartment to connect to the battery. This will damage the lead insulation and cause a very dangerous short. • Do not shorten any leads. If you do, the protection circuit may fail to work when it should. • Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. The current capacity of the lead will be exceeded, causing overheating. • When replacing fuse, be sure to use only fuse of the rating prescribed on the fuse holder. • To prevent incorrect connection, the input side of the IP-BUS connector is blue, and the output side is black. Connect the connectors of the same colors correctly. • If this unit is installed in a vehicle that does not have an ACC (accessory) position on the ignition switch, the red lead of the unit should be connected to a terminal coupled with ignition switch ON/OFF operations. If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. (Fig.1) F ACC O F O T T ACC position No ACC position Fig. 1 • Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. When Connecting the Multi-Channel AV Master Unit Green Multi-Channel AV Master Unit (e.g. AVM-P9000R) (sold separately) Yellow Blue Blue Optical cable (supplied with the Multi-Channel AV Master Unit) IP-BUS cable (supplied with the TV tuner) FM MODULATOR IP-BUS MAIN UNIT IP-BUS AV MASTER RCA cable (sold separately) 20 pin cable (supplied with the TV tuner) Black Blue Hide-away TV Tuner (e.g. GEX-P7000TV) (sold separately) Green Red Gray IP-BUS STAND ALONE Black Yellow (front video output) This product 15 cm RCA cable (supplied) Yellow IP-BUS cable 6m (supplied with the Multi- Blue Channel AV Master Unit) Blue 40 cm Not used. Blue V.SEL cable (supplied with the display) Speaker Unit (supplied with the display) Multi-CD player (sold separately) Blue AV system Display (e.g. AVX-P7000CD) (sold separately) AV cable (supplied with the Multi-Channel AV Master Unit) Black IP-BUS cable (supplied with the display) Green Gray Gray 20 pin cable (supplied with the display) Fig. 2