Pioneer SX-SW560 Owner's Manual - Page 20

05 Getting started Chapter 5 Getting started Important • Many of the buttons used extensively in this chapter are used in conjuction with the SHIFT button. The cursor buttons ( / / / ), ENTER, SETUP and MCACC should all be used with SHIFT in the following explanations. System demo setting Switches the automatic demo feature on or off (this starts when you plug in for the first time). ENTER TOP MENU SR SURROUND ADVANCED CLEAR TUNE MENU SOUND SETUP ST ENTER ST TEST TONE / TUNE RETURN MCACC / SOUND AUDIO SUBTITLE ANGLE RETRIEVER PLAY MODE ZOOM DISPLAY SLEEP TV INPUT CHANNEL VOLUME SHIFT TV CONTROL 1 Switch the system into standby. 2 Press SHIFT+SETUP. 3 Use the SHIFT+ / (cursor left/right) buttons to select DEMO from the menu, then press SHIFT+ENTER. 4 Use the SHIFT+ / (cursor up/down) buttons to select a setting, then press SHIFT+ENTER. Select from: • DEMO ON - Switches the demo display on. • DEMO OFF - Switches the demo display off and the system into standby. Using the Auto MCACC setup for optimal surround sound The Multichannel Acoustic Calibration (MCACC) system measures the acoustic characteristics of your listening area, taking into account ambient noise, and testing for channel delay and channel level. After you have set up the microphone provided, the system uses the information from a series of test tones to optimize the speaker settings and equalization (Acoustic Calibration EQ) for your particular room.1 Important • The test tones used for Auto MCACC setup are loud; however, do not turn the volume down during setup as this may result in a sub-optimal setup. • Make sure the microphone and speakers are not moved during the MCACC setup. ENTER TOP MENU ADVANCED CLEAR TUNE MENU DVD MUTE VOLUME RECEIVER DVD DTV PC/GAME AUX TUNER SOUND SETUP ST ENTER ST TEST TONE / TUNE RETURN MCACC / SOUND AUDIO SUBTITLE ANGLE RETRIEVER PLAY MODE ZOOM DISPLAY SLEEP TV INPUT CHANNEL VOLUME SR SHIFT TV CONTROL SURROUND 1 Connect the microphone to the MCACC SETUP MIC jack on the rear panel. MCACC CONTROL IN SETUP MIC CONTROL SPEAKERS SYSTEM CONNECTOR OUT SUB WOOFER R SURROUND L ANTENNA FM UNBAL 75Ω AM LOOP ANTENNA AUDIO INPUT DIGITAL DVD DTV PC/GAME (COAXIAL) (OPTICAL) (OPTICAL) ANALOG AUX L USE ONLY WITH DISPLAY UNIT. R SEE INSTRUCTION MANUAL. CENTER R FRONT L AC IN 2 Place the microphone at your normal listening position. Place the mic horizontally about ear level at your normal listening position using a table or chair. Make sure there are no obstacles between the speakers and the microphone. Note 1 You only need to use the Auto MCACC setup once (unless you change the placement of your speakers or your room layout). 20 En