Pioneer VSX-29TX Owner's Manual - Page 50

Remote Control of Other Components 5 6 DVD:OK RECEIVER DVD/LD EXIT REMOTE SETUP 123 MD/TAPE1 TV/SAT VCR1 VCR2 SEARCH 4 5 MODE TOP 7 8 MENU MENU SET UP 10 0 6 CD 9 TUNER C TV CONTROL 5 Point the two remote controls toward each other. Press the button on the other remote control corresponding to the operation you want to program. LEARNING flashes in the display on the remote control. After the process is complete and the command has been learned, OK will appear at the top of the remote control LCD display. If NG (no good) appears, it means that for some reason the command was not learned. Repeat steps 4 and 5 to teach the remote control of the VSX-29TX all the commands from remote control. « EXIT 5 ~ 12 inches Learning RECEIVER DVD/LD EXIT REMOTE SETUP MD/TAPE1 TV/SAT VCR1 VCR2 SELECT FUNCTION CD TUNER TV CONTROL 6 Press EXIT to return to the LEARNING/SELECT FUNCTION screen. Start again from step 3 to program all your components in this manner. When you're done press EXIT repeatedly to return to the REMOTE SETUP menu. memo Some commands from other remote controls cannot be learned, but in most cases the remotes just need to be moved closer together or farther apart. Locking the Settings This feature allows you to lock the SYSTEM SETUP and REMOTE SETUP settings so that they cannot be changed without unlocking them first. When they are locked you cannot enter the setting screen in these modes. The locking and unlocking procedures are done by the same procedure. 1 Lock symbol RECEIVER DVD/LD Remote Setup EXIT LCD COMMANDER MULTI OPERATION REMOTE SETUP MD/TAPE1 TV/SAT PRESET RECALL DIRECT FUNCTION CD VCR1 VCR2 LEARNING TUNER TV CONTROL on off BACK LIGHT TV CONTROL FUNCTION CH + CH - VOL + VOL - FUNCTION ENTER STANDBY/ON MULTI SYSTEM OPERATION OFF MUTING MASTER VOLUME + - 1 In the SYSTEM SETUP or REMOTE SET UP screens hold down the %¥fi buttons at the same time. A lock symbol with a box around it will appear in the top bar of the LCD screen. 2 Press the lock symbol while holding down the above two keys. The setting will either lock or unlock depending on the state it was previously in. From that time, if the screen is locked the lock symbol will appear when that screen is accessed. 2 RECEIVER DVD/LD Remote Setup EXIT LCD COMMANDER MULTI OPERATION REMOTE SETUP MD/TAPE1 TV/SAT PRESET RECALL DIRECT FUNCTION CD VCR1 VCR2 LEARNING TUNER TV CONTROL on off BACK LIGHT TV CONTROL FUNCTION CH + CH - VOL + VOL - FUNCTION memo The only exception to LOCKING THE SETTINGS is the LCD COMMANDER settings in the REMOTE SETUP screen. They can still be accessed even when the REMOTE SETUP screen is locked. ENTER STANDBY/ON MULTI SYSTEM OPERATION OFF MUTING MASTER VOLUME + - 50