Pioneer VSX-33TX Owner's Manual - Page 11

PREPARATION Before You Start Operating range of remote control unit The area in which you can use the remote control to operate the VSX-33TX is fairly large. To use, point the remote control toward the remote sensor on the front panel of this unit while within the range shown right. Remote control may not function properly if: • There are obstacles between the remote control and the remote sensor. • Direct sunlight or fluorescent light is shining onto the remote sensor. • The receiver located near a device emitting infrared rays. • Operated simultaneously with another remote control which 4 ST THX 2 AV PRREEM-PORTOEGCROANMTRMOELDUANNIDT LEARNING / DTS & MPX D.ACCESS GUIDE TUNE ADVMANIDCNEIGDHTSTRAENCDDESAIPRVREEDRTUDMRIRUSNETTCEETRSCE.MOOONDTFRUENOCLTIOCNLEARDTDVTOVNIN/ OFOFF BAND DTV MENU MENU CLASS Î TUNE ENTER DVD CD SOURCE 7 48 15 2 3 TV 0 9 6 CHANNEL EFFECT/C+H1S0ELREMOTE SETUP VOL TVFTUVNCKONTROLTV RECEIVER MASTER VOLUME SINYPSUTETMATSTETUEPNLTOSDEUIIRGGDNINTAEALSLSSNDERILSECCVTIDEFOLSDEIMLMECETR CD-R MULTTIUCTNOVNTROL MULTI CH INPUT 1 VCR TVC ¢ RECEIVER 2 VCR ST uses infrared rays. Installing the Receiver 30 30 23 feet (7m) Please note: • Do not place objects directly on top of this unit. This would prevent proper heat dispersal. • When installing in a rack, shelf, etc., be sure to leave more than 8 inches of space above the receiver. Opening the Front Panel 8 inches (20 cm) Receiver To open the front panel push gently on the lower third of the panel with your finger. The PIONEER SR System: Operating other PIONEER components Connecting an optional control cord allows you to operate other PIONEER components simply by pointing the receiver's remote control at the remote sensor on the front panel of the receiver. The receiver then sends the remote control signals to the other devices via the CONTROL OUT terminal. CONTROL IN OUT Receiver Remote Control SOURCE RECEIVER DVD CD TV VCR 1 MULTI CONTROL CD-R TUN VCR 2 TVC 1 2 3 LOUDNESS VIDEO SELECT MULTI CH INPUT 4 INPUT ATT 5 DIGITAL NR 6 FL DIMMER 7 8 9 REMOTE SETUP SYSTEM SETUP SIGNAL SELECT +10 DISC 0 ENTER EFFECT/CH SEL RECEIVER TV VOL TV MASTER VOLUME TV CONTROL TVFUNK 4 CHANNEL ¢ TUNE ST ST ENTER TUNE GUIDE D.ACCESS & BAND ‹ MENU CLASS * MPX DTV ON / OFF DTV MENU ¶ !⁄ RETURN S.MODE CLEAR DTV INFO RECEIVER DIRECT CONTROL MIDNIGHT DSP STEREO FUNCTION THX ADVANCED STANDARD MUTE 2 / DTS Î AV PRE-PROGRAMMED AND LEARNING REMOTE CONTROL UNIT PIONEER component bearing the Î mark. To CONTROL IN terminal of another PIONEER component bearing the Î mark. memo • You can also control PIONEER components (and those made by other manufacturers) by pointing the receiver's remote control directly at the respective component. This type of operation does not require control cords. All you have to do is recall the appropriate the stored settings (see p.58-59). • If you use a remote control hooked up via the CONTROL IN jack with a control cord, you won't be able to use this unit's remote control. 11