Pioneer VSX-33TX Owner's Manual - Page 58

Remote Control of Other Components Programming a Different Component into a MULTI CONTROL button This feature changes a selected Multi Control button to a different component. For example, if you don't have a second TV, but you do have a second DVD, you could reassign the TV Multi Control to DVD so that DVD control buttons are available when you select TV. 3 1 SOURCE RECEIVER DVD CD TV VCR 1 MULTI CONTROL CD-R TUN VCR 2 TVC 1 2 3 LOUDNESS VIDEO SELECT MULTI CH INPUT 4 INPUT ATT 5 DIGITAL NR 6 FL DIMMER 7 8 9 REMOTE SETUP SYSTEM SETUP SIGNAL SELECT +10 DISC 0 ENTER EFFECT/CH SEL RECEIVER TV VOL TV MASTER VOLUME TV CONTROL TVFUNC 4 ¢ 2,4 3 1 Press REMOTE SETUP and hold for three seconds. The LED on the remote will blink twice. 2 Press the MULTI CONTROL button which you want to change. For the example above, press TV. 3 Press 9, 9, then 2. 4 Press the MULTI CONTROL button which you want to be duplicated. In the above example, press TV. The LED will blinks twice. The TV button will now make the remote function as a DVD controller. Remember to assign the correct preset code for your equipment (the default is for Pioneer equipment). Checking Preset Codes 2 1 3 SOURCE RECEIVER DVD CD TV VCR 1 MULTI CONTROL CD-R TUN VCR 2 TVC 1 2 3 LOUDNESS VIDEO SELECT MULTI CH INPUT 4 5 6 INPUT ATT DIGITAL NR FL DIMMER 7 8 9 REMOTE SETUP SYSTEM SETUP SIGNAL SELECT +10 DISC 0 ENTER EFFECT/CH SEL RECEIVER TV VOL TV MASTER VOLUME TV CONTROL TVFUNC 4 CHANNEL ¢ TUNE ST ST ENTER TUNE GUIDE D.ACCESS & BAND ‹ MENU CLASS * MPX DTV ON / OFF DTV MENU ¶ !⁄ RETURN S.MODE CLEAR DTV INFO RDM RECEIVER DIRECT CONTROL MIDNIGHT DSP STEREO FUNCTION THX ADVANCED STANDARD MUTE 2 / DTS Î AV PRE-PROGRAMMED AND LEARNING REMOTE CONTROL UNIT 58 To check which preset code is associated with a Multi Control button: 4-7 3 1 Press REMOTE SETUP and hold for three seconds. The LED on the remote will blink twice. 2 Press the MULTI CONTROL button you want to check the preset code for. 3 Press 9, 9, then 0. Each preset code consists of four digits, for example 1329. Each digit will be represented by a series of blinks on the remote's LED-3 blinks to represent the digit "3", etc. 4 Press 1. The blinking LED indicates the left-most digit of the preset code ("1" in the example above). 5 Press 2. The blinking LED indicates the next digit of the preset code ("3" in the example above). 6 Press 3. The blinking LED indicates the next digit of the preset code ("2" in the example above). 7 Press 4. The blinking LED indicates the right-most digit of the preset code ("9" in the example above).