Pioneer VSX-33TX Owner's Manual - Page 24

Displays & Controls Remote Control 1 2 3 4 5 6 7 8 9 0 = ~ ! @ # $ SOURCE RECEIVER DVD CD TV VCR 1 MULTI CONTROL CD-R TUN VCR 2 TVC 1 LOUDNESS 2 3 VIDEO SELECT MULTI CH INPUT 4 INPUT ATT 5 DIGITAL NR 6 FL DIMMER 7 8 9 REMOTE SETUP SYSTEM SETUP SIGNAL SELECT +10 DISC 0 ENTER EFFECT/CH SEL RECEIVER TV VOL TV MASTER VOLUME TV CONTROL TVFUNC 4 CHANNEL ¢ TUNE ST ST ENTER TUNE GUIDE D.ACCESS & BAND ‹ MENU CLASS * MPX DTV ON / OFF DTV MENU ¶ !⁄ RETURN S.MODE CLEARDTV INFO RDM RECEIVER DIRECT CONTROL MIDNIGHT DSP STEREO FUNCTION THX ADVANCED STANDARD MUTE 2 / DTS Î AV PRE-PROGRAMMED AND LEARNING REMOTE CONTROL UNIT % ^ & * 1 SOURCE button Use to turn on/off other components connected to the receiver. 2 MULTI CONTROL buttons Use to put the receiver/remote control in the stated mode. For other equipment controls, see Controlling the Rest of Your System on pages 55-59. 3 Number/MODE buttons Use the number buttons to select the radio frequency in tuner DIRECT ACCESS mode or the tracks in CD, DVD mode etc. Also, buttons marked with the following names have special functions. If you try to use one of these functions but the display flashes it means that function cannot be used in the current mode (for example DSP modes cannot be used when 5.1 CH setting is on). LOUDNESS button Use to switch on the loudness. This feature is useful for getting good bass and treble sounds listening at low volumes. 24 VIDEO SELECT button Switches the receiver between the various types of video input. MULTI CH INPUT button Use to hook up an external component that can decode other types of signals and input them into the VSX-33TX (see p.48). INPUT ATT button Use to lower the input level of an analog signal that is too powerful, thus causing the sound to distort (the OVER indicator will light when this is the case). DIGITAL NR button Press to switch Digital NR on or off. (See page 45) FL DIMMER button Use to adjust the brightness of the fluorescent display (FL = fluorescent display). Four levels of the brightness ranging from very dim to very bright can be selected. Each press changes the brightness of the display. REMOTE SETUP button Use to customize the remote control functions and the remote control itself. (See "Remote Control of Other Components" starting on p.55.) SYSTEM SETUP button Use to set up the speaker and sound systems. For more information see "Setting Up for Surround Sound" starting on p.27. SIGNAL SELECT button Press SIGNAL SELECT repeatedly to select one of the following: ANALOG - Analog signal. DIGITAL - Digital signal (DVD/LD, TV/SAT, CD, CD-R/TAPE 1/MD, VCR 1/DVR, VCR 2). AUTO - This is the default. If there are analog, or digital signals input the receiver automatically selects the best possible signal. EFFECT / CH SEL button For DSP/advanced theater sound modes use to put into the mode to add or subtract the amount of effect. For other sound modes use to select individual channels to increase or decrease channel level. EFFECT +/- buttons Use to add or subtract the amount of effect in different DSP/advanced listening sound modes or the level of individual channels. ENTER button (DISC) Use to enter commands into TVs or DTVs. For CD players use to change discs.