Pioneer VSX-33TX Owner's Manual - Page 35
Ch Level End - weight
View all Pioneer VSX-33TX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
SET UP Initial Setup 4-6 SOURCE RECEIVER DVD CD TV VCR 1 MULTI CONTROL CD-R TUN VCR 2 TVC 1 2 3 LOUDNESS VIDEO SELECT MULTI CH INPUT 4 INPUT ATT 5 DIGITAL NR 6 FL DIMMER 7 8 9 REMOTE SETUP SYSTEM SETUP SIGNAL SELECT +10 DISC 0 ENTER EFFECT/CH SEL RECEIVER TV VOL TV MASTER VOLUME TV CONTROL TVFUNC 4 CHANNEL ¢ TUNE ST ST ENTER TUNE GUIDE D.ACCESS & BAND ‹ MENU CLASS * MPX DTV ON / OFF DTV MENU ¶ !⁄ RETURN S.MODE CLEAR DTV INFO RDM RECEIVER DIRECT CONTROL MIDNIGHT DSP STEREO FUNCTION THX ADVANCED STANDARD MUTE 2 / DTS Î AV PRE-PROGRAMMED AND LEARNING REMOTE CONTROL UNIT 4 Adjust speaker levels so that you hear the test tone at the same volume from each speaker when seated in your main listening position. Note: The volume of the subwoofer tends to sound lower than it actually is, you may need to raise its level after testing the sound with actual soundtracks. In AUTO mode The receiver will automatically cycle through the speakers emitting a test tone from each one. It will continue to do this until you press ENTER to signify you have finished your adjustments. In MANUAL mode 1 Press ENTER 2 Press the 5/∞ buttons (or the MULTI JOG dial) to adjust the level of the speaker outputting the TEST TONE. 3 Press ENTER again to input the information and move to the next channel. 4 Repeat 1, 2 and 3 for each speaker. If you are using a Sound Pressure Level (SPL) meter Take the readings from your main listening position and adjust the level of each speaker to 75 dB SPL (C-weighted/slow mode). 5 When you have adjusted each speaker level and entered the information "Ch Level End" will be selected. Press ENTER . It will again take a moment as the MASTER VOLUME returns to its original position. 6 Press ENTER again to return to go to the memo "Crossover" settings. Next, proceed to Crossover Network on the next page. Note that it is also possible to set channel levels temporarily. Then follow the same procedure as explained on this page. This function is designed to be used when you want to change the levels temporarily to raise the level of one channel. Using this method you can set speaker levels in different modes, such as, STEREO, and each DSP mode, independently. You should return the settings to their original state when done. Doing the set up procedures on this page will erase any temporary/independent level settings that have been made. If you want to change a setting before proceeding use the 5/∞ buttons (or the MULTI JOG dial) to go back. 35