Pioneer VSX-515-S Owner's Manual - Page 20
Twist exposed wire strands together., Loosen terminal and insert exposed wire., Tighten terminal. - no sound
View all Pioneer VSX-515-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
03 Connecting up Connecting the speakers (VSX-515) A complete setup of eight speakers (including the subwoofer) is shown below, but everyone's home setup will vary. Simply connect the speakers you have in the manner shown below. The receiver will work with just two stereo speakers (the front speakers in the diagram) but using at least three speakers is recommended, and a complete setup is best for surround sound. If you're not using a subwoofer, change the front speaker setting (see Speaker setting on page 42) to large. Make sure you connect the speaker on the right to the right terminal and the speaker on the left to the left terminal. Also make sure the positive and negative (+/-) terminals on the receiver match those on the speakers.1 You can use speakers with a nominal impedance between 6-16Ω (please see Switching the speaker impedance on page 51 if you plan to use speakers with an impedance of less than 8Ω). Be sure to complete all connections before connecting this unit to the AC power source. Front speakers Center speaker L R C Surround speakers Surround back speakers LS RS SBL SBR R AUDIO L IN CD FM UNBAL 75 Ω AM LOOP ANTENNA OUT OPT IN 1 (TV/SAT) IN ASSIGNABLE DIGITAL IN IN COAX 2 (CD) OUT COAX 1 (DVD /LD) IN DVR/ VCR IN TV / SA T IN DVD /LD FRONT D V D 5.1CH REC INPUT CD-R IN / TAPE / MD PLAY VIDEO OUT MONITOR OUT SUB WOOFER PREOUT CEN- SUB TER WOOFER R L SURROUND DVD 5.1CH INPUT COMPONENT VIDEO ASSIGNABLE (DVD / LD) IN ¥ Y PB PR Y PB PR MONITOR OUT (T V / SAT)IN ø S R FRONT L CENTER R SURROUND BACK L R SURROUND L P E A SINGLE K SEE INSTRUCTION MANUAL E R S AC OUTLET VSX-515 Single surround Powered subwoofer SW back speaker 1 2 3 INPUT 10mm or 1 Twist exposed wire strands together. 2 Loosen terminal and insert exposed wire. • The speaker terminals also accept single banana plugs. 3 Tighten terminal. Note 1 If you are using only one surround back speaker, connect the positive wire to the right channel (+) terminal, and the negative wire to the left channel (-) terminal (see illustration). 20 En