Pioneer VSX-515-S Owner's Manual - Page 50
Lfeat 0, Lfeat
View all Pioneer VSX-515-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
10 Additional information Problem Remedy Broadcast stations cannot be • Connect an outdoor antenna (refer to page 18). selected automatically. No sound from surround or center speakers. • Connect the speakers properly. Refer to page 19 (VSX-415) or page 20 (VSX-515). • Refer to Speaker setting on page 38 (VSX-415) or page 42 (VSX-515) to check the speaker settings. • VSX-415 only - Refer to Setting separate channel levels for listening modes on page 40 to check the speaker levels. • VSX-515 only - Refer to Channel level on page 43 to check the speaker levels. No sound from surround • Refer to Speaker setting on page 42 to check the surround back back speakers (VSX-515 model speaker settings. only). • Refer to Channel level on page 43 to check the speaker levels. • Refer to Using the surround back channel (Extended mode) on page 33 to make sure the Extended mode and the sound mode are set for surround back sound. No sound from subwoofer. • Make sure the subwoofer is switched on. • If the subwoofer has a volume knob, make sure it's turned up. • The Dolby Digital or DTS source you are listening to may not have an LFE channel. VSX-415 model only: • Switch the Subwoofer setting on page 38 to YES or PLUS. • Switch the LFE attenuator setting on page 38 to 0 dB or 10 dB. VSX-515 model only: • Switch the subwoofer setting in Speaker setting on page 42 to YES or PLUS. • Switch the LFE Attenuator Setup on page 45 to LFEAT 0 or LFEAT 10. Noise during playback of a • Move the cassette deck further from your receiver, until the noise cassette deck. disappears. Sound is produced from other components, but not from LD or DVD player. • Set the SIGNAL SELECT to AUTO, DIGITAL or ANALOG according to the type of connections made. (refer to page 32). • Set the digital input settings correctly. Refer to page 40 (VSX-415) or page 44 (VSX-515). • Make digital connections (refer to page 13) and set the SIGNAL SELECT to DIGITAL (refer to page 32). • Refer to the instruction manual supplied with the DVD player. No sound is output or a noise • Set the digital volume level of the player to full, or to the neutral is output when software with position. DTS is played back. 50 En