Pioneer VSX-515-S Owner's Manual - Page 8

02 5 minute guide 3 Connect your speakers. A complete setup of speakers is shown here (six speakers for the VSX-415, and eight for the VSX515), but home setups may vary. Simply connect the speakers you have as shown below.1 The receiver will work with just two stereo speakers (the front speakers in the diagram) but using at least three speakers is recommended, and a complete setup is best. Make sure you connect the speaker on the right to the right terminal and the speaker on the left to the left terminal. Also make sure the positive and negative (+/-) terminals on the receiver match those on the speakers. You can use speakers with a nominal impedance between 6-16Ω (please see Switching the speaker impedance on page 51 if you plan to use speakers with an impedance of less than 8Ω). Front speakers L R Center speaker Surround speakers C LS RS R AUDIO L IN CD FM UNBAL 75 Ω AM LOOP ANTENNA OUT DIGITAL IN IN OPT 1 (TV / SA T ) IN ASSIGNABLE COAX 2 (CD) IN COAX 1 (DVD OUT /LD) IN DVR/ VCR IN TV / SA T IN DVD /LD FRONT D V D 5.1CH REC INPUT CD-R IN / TAPE / MD PLAY VIDEO OUT MONITOR OUT SUB WOOFER PREOUT CENTER SUB WOOFER R L SURROUND DVD 5.1CH INPUT FRONT SPEAKER RL CENTER SPEAKER SURROUND SPEAKERS RL L R SURROUND PREOUT Powered subwoofer SW INPUT AC OUTLET VSX-415 Note 1 • If you're not using a subwoofer, change the front speaker setting (see Speaker setting on page 38) to large. • VSX-515 only - If you are using only one surround back speaker, connect the positive wire to the right channel (+) terminal, and the negative wire to the left channel (-) terminal as shown. 8 En